1996 Chrysler Town & Country Logo

Related Topics:

A
Anonymous Posted on Sep 19, 2014

My 1996 Chrysler town and country van is making a

My 1996 Chrysler town and country van is making a noise and feels like it is misfiring

1 Related Answer

Anonymous

  • 1 Answer
  • Posted on Jan 28, 2010

SOURCE: CHRYSLER town and country mini van turn signal/flasher

I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.

Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.

If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)

Your going to replace it anyway, whats the harm?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

#1 cylinder is misfiring, put new fuel ejector and the problem is still there.It has a bad noise in the motor.

Thread: Cylinder 1 misfire P0301 - The Chrysler Minivan Fan Club ...

forum.chryslerminivan.net/showthread.../27978-Cylinder-1-misfire-P03...

Feb 6, 2013 - 7 posts - ‎4 authors
My mother-in-law's 2002 Town and Country has the P0301 cylinder 1 misfire error code. I haven't done much work on this type of car, so I'm not ... '05 Town & Country Cylinder 1 misfire mystery
10 posts
Feb 3, 2014
Engine misfire
7 posts
May 6, 2012
#1 Cylinder misfires at idle only
10 posts
Jun 4, 2011
Running rich / Misfire Mystery
10 posts
Sep 20, 2010
More results from forum.chryslerminivan.net

Part 1 -How to Test the Coil Pack (2001-2008 Chrysler 3.3L ...

easyautodiagnostics.com > Chrysler > 3.3L, 3.8L
Apr 29, 2011 - Page 1 of 7: How to Test the Coil Pack (2001-2008 Chrysler 3.3L, 3.8L). ... This article will help you troubleshoot a Misfire Condition that might be setting ...your 2001-2009 Chrysler (or Dodge) 3.3L or 3.8L Town and Country, Voyager, ... it's important the you know what 'Paired Cylinders' and 'Non-Paired ...
0helpful
1answer

2000 chrysler town and country wont start and makes ticking noise when ignition switch is turned on

have a load test done on the battery
have the charging system properly checked by an auto electrician
1helpful
1answer

Trying to locate the fuel filter for a 1996 Chrysler Town and Country van

1996 Chrysler Truck Town & Country 4WD 3.8L MFI 6cyl
The Fuel Filter is located under vehicle, driver side, below seating area, front of fuel tank, mounted on frame rail in fuel line.

Hope help with this (remember rated this).
1helpful
1answer

1996 town & country van front heater blower

you will need to start by checking fuse,then power to motor,then blower motor resistor
0helpful
1answer

Interiour lights staying on all the time

make sure the adjustment for your dash lights is not pushed all the way to the top .
0helpful
1answer
0helpful
1answer

I was driving the van and it just shut off.

Our mechanic replaced the fuel sensor in our van and solved this problem.
2helpful
1answer

All the accessories are dead on my 1996 town & country .

this problem is caused by a defective BCM (body control module)
0helpful
1answer

1996 CHRYSLER TOWN & COUNTRY TRANS AXLE PROBLEM.

i had same toublre on 96 plymouth output speed senor my wont shift out of second
0helpful
1answer

Town and country

CHECK FOR INLET MANIFOLD LEAKS OR EGR LEAKS..
Not finding what you are looking for?

66 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...