2001 Chrysler Concorde Logo

Related Topics:

A
Anonymous Posted on Sep 18, 2014

2001 Chrysler Concorde Wire digram

Coloer code wireing digram

5 Related Answers

Anonymous

  • 156 Answers
  • Posted on Mar 25, 2009

SOURCE: 2001 chrysler concorde engine codes

P0455 Evaporative Emission Control System Leak Detected (gross leak) - check your entire engine bay contents for any type of leak, air conditioner when it's running, coolant, things like that.

P1684 Battery Disconnected Within Last 50 Starts - this is a code that will go away over time

Ad

Anonymous

  • 3533 Answers
  • Posted on May 05, 2009

SOURCE: fuel filter for 2001 chrysler concorde

for the most part it on the driver side under the car close to the frame of the passenager side just in front of the rear tire in the frame also checkout this website to see if they have your car listed its www.autozone.com if they do you be able to get pictures and diagram showing you where its located on your car.

Anonymous

  • 1392 Answers
  • Posted on May 29, 2009

SOURCE: I have a 2000 chrysler concorde that the engine light just popped on - the error codes are po302, po420, po340

P0302-cylinder #2 misfire detected
P0420- catalyst efficiency below threshold bank 1
P0340-No cam signal at PCM.
The Cam sensor most likely needs to be replaced first. Clear the codes after that and drive and see what comes back on.

Robert Debison

  • 412 Answers
  • Posted on Aug 31, 2009

SOURCE: i have a 2001 chrysler concorde. the trouble codes

I RECOMMEND REPLACING THE OUTPUT SPEED SENSOR..ABOUT 40 BUCKS..WILL CAUSE THESE OTHER FAULT CODES AS WELL

Anonymous

  • 122 Answers
  • Posted on Sep 12, 2009

SOURCE: HOW DO I CHANGE THE BATTERY IN MY 2001 CHRYSLER CONCORDE?

You will need to disengage the Negative terminal (Black side) and then the Red (positive side). In addition, there might be a securing bracket with two bolts or wing nuts, loosen these and the rods can be pushed down and twist out of the bottom. Once this is done remove the battery and head to your local Auto parts store, they can help you select the correct one. re-assemble as you have taken apart. you will need to re program your stereo and reset your clock, (prior to removing terminals) make sure there are no special lock out codes for your stereo. Good luck!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Disarming the anti theft system in a 1996 Chrysler Concorde so I can drive my car

Disconnecting the Factory Alarm should not be done, as there are a number of components that is connected to it (Lights, Horn, Ignition, Door Locks, etc.)
It would be better if you "disabled" it
Find the LIGHT GREEN / ORANGE wire located in the harness in the Driver Kick Panel / Door Boot area.

Remove the Driver Kick Panel next to door & the connector should be in that area

2009-03-24_204525_dodd-wpfsb3viqmjpnlor3p3j4z2t-4-0.gif
Do not cut in half,
Splice in one end of the piece of wire to the LIGHT GREEN / ORANGE wire
Connect the other end of the piece of wire to Ground, to a part of vehicles frame

at this link tells disarm wire color.

1996 Chrysler Concorde Car Security Wiring Diagram ModifiedLife com
0helpful
1answer

2001 Chrysler Concorde, need to disable GPS tracker put on by previous owner

gps tracker should be plugged into ob2 port trace wires out one by one and disconnect if the spliced into a wire unplug it if a wire is cut to loop through tracker first remove and reconnect cut wires recommend soldering and heat shrinking cut wires
0helpful
1answer

Replace alternator on 2001 chrysler concord

disconect battery, remove belt, remove power wire from alt, remove wire plug from alt. remove two bolts holding alt to braket, pull out alt. reverse to instal
0helpful
1answer

Steps to change starter on 2001 chrysler concorde?

Unhook battery ground, Remove starter bolts, remove wires, reverse procedure to reinstall
0helpful
1answer

1997 Chrysler Concorde Lx problem code from Advanced Auto was P1698 and it said to check with manufacturer. They dont know either, computer does not go back that far. What does this mean?

no message received from the transmission control module. The bus system is the communication system the computers use to send information back and forth. Anything from a bad fuse, bad wire, or a faulty computer can cause that code.
1helpful
1answer

PO740 error what is it and how do I fix, 2001 Chrysler Concorde 2.7 liter. Also error codes PO732 and PO733.

These are trasmission codes my advise would be to take it to a shope for further diagnosis.
0helpful
1answer

I have a 2001 chrysler concorde. the trouble codes

I RECOMMEND REPLACING THE OUTPUT SPEED SENSOR..ABOUT 40 BUCKS..WILL CAUSE THESE OTHER FAULT CODES AS WELL
0helpful
1answer

Code p1698 for a 1998 chrysler concorde 2.7 i dont know what it means and noone seems to be able to tell me

Code p1698 means there is no digital data being recieved from the transmission control module to the power train or the other way around.
Take it and have the wire harness checked between the two modules, might have bad connection or bad wire. Also have the two modules checked, one might be bad.
They are expensive, so it's best to find out which one is bad, if it's not a bad wire, or dirty connection.
4helpful
1answer

2001 chrysler concorde engine codes

P0455 Evaporative Emission Control System Leak Detected (gross leak) - check your entire engine bay contents for any type of leak, air conditioner when it's running, coolant, things like that.

P1684 Battery Disconnected Within Last 50 Starts - this is a code that will go away over time
Not finding what you are looking for?

128 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...