Replaced blower motor resistor but fan for heat and ac works on high only. suspect switch is bad. would like wiring diagram for blower motor switch to test switch to verify its bad.
SOURCE: how to replace a blower motor resistor in a 2004 jeep liberty
You have to take the glove box off and it is right behind it, need a #20 Torx to take it replace it. The glove box is the hardest part of the job, I just replaced mine on an 05 Grand Cherokee but it didn't fix it for me, was well worth the $8.60 to try though.
SOURCE: AC blower motor resistor Nissan Maxima 2000
yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,
SOURCE: On my 1999 Buick LeSabre the blower fan does not work at all
How about checking voltage into & out of resistor for difference. Some swear by high only when resistor goes, but in past I have had intermittent use of other speeds before it finally went & I had high only.
SOURCE: 1995 Jeep Cherokee AC blower doesn't work.
do you have feed to blower motor ?? sorry CSI is coming on TV now and er indoors is screaming that i spent too long on here '¡'¡'¡'¡'¡ usual ----typical woman ,if you have her i will throw my jag in the deal for free
SOURCE: blower motor fan works on high setting only
The resistors are located in the firewall just above the blower motor. they have a heavier gadge wire going to it. As for the water if it is not antifreeze then you have a leak in your cowl area by the lower windshield. I ran in to this problem on several gm cars such as yours it can be deficult to find good luck
Testimonial: "Iccjester, thanks for the information it was very helpful much appreciation Mike S 1999 Buick Century"
591 views
Usually answered in minutes!
×