The horn in my Santa Fe stopped working
When pushing on the horn pad you may hear a click noise this tells you the circuit is good from the horn pad to the horn relay and out to the horn. find the horn and check for power at the horn terminal when the horn pad is pushed. if it lights up then replace the horn. if it doesn`t then you will have to check for a wire problem from the horn back to the relay. but horns are usually the problem.
SOURCE: 2003 Hyundai Santa Fe clock stopped working
1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correct?
SOURCE: 2003 Santa fe timing belt change
You can drive it till it breaks of course, that will cost much more then replacing it as maintenance though. I would plan to have it changed much sooner then later as you are already past your recomended service time.
SOURCE: Hyundai Santa Fe Windscreen Washer Motor Fault
try taking a pin and cleaning the holes on the squirters and if that does not work check the washer pump it is located on the washer fluid tank
SOURCE: Hyundai Santa Fe 2005 won't shift into first gear
Most likely the o-ring seal between the torque converter and the transmission is going bad. Get that transmission rebuilt pronto before serious damage is done! But first, have a mechanic drop the transmission pan and look for signs of a very thin silvery film coating the inside of the pan. If found, then the transmission definitely will have to be rebuilt, and the torque converter will also have to be replaced since embedded metallic particles in the old torque converter will eventually come loose, due to wear of the clutch plates within the torque converter, and eat up the rebuilt transmission. Now, here is the deal once the transmission has been rebuilt:
Change the transmission fluid and filter once a year -- no matter what! If you do this, then you should never have any more problems with the transmission.
SOURCE: PROGRAM KEYFOB FOR HYUNDAI SANTA FE
This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.
1,336 views
Usually answered in minutes!
×