How do i remove the speed limiter on an 02 chry 300 m or is it a wire that has to be cut ?

There's this website www.reliable-store.com
They
have books on ALL vehicles.
it covers wiring diagrams, electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, owner's/service/repair/parts/maintenance manuals etc everything totally..
I have 1987 toyota 4runner model and I keep servicing and when needed repair it on my own. worth it !!!

There's this website www.reliable-store.com
They have books on ALL vehicles.
it covers wiring diagrams, electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, troubleshooting owner's/service/repair/parts/maintenance manuals etc everything totally..
I have 1987 toyota 4runner model and I keep servicing and when needed repair it on my own. worth it !!!

images for aldl connector wiring

pls post the MODAL before u post

thanks in advancement,
din
g

similar problem recently on an '02 sable.it was the EATC--Electronic Automatic Temperature Control module,located behind the dashboard,it has vacuum tubes and many wires connected to it.check vacuum lines for a leak,but the lack of fan speed control points to the auto module.Ford wanted $300,found one in a junk yard for $50.Good luck

A wheel speed sensor?

They are located at each individual wheel.

An output or input speed sensor?

They are located on the drivers side of the transmission. They are yellowish white in color and look identical to each other. You will need a 1 inch socket to remove and replace them.

The input speed sensor is towards the front of the transmission and the output speed sensor is located toward the rear of the transmission.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Right in the front of the engine,on the top you are going to see the radiator hose connected to the part where the thermostat is inside.

Has the car been wrecked? Look at a parts book at the dealership and see if it has an air deflector under the front end, this is supposed to push air thru the radiator at cruise speed, and if it is missing she will run hot at cruise speed.

Most obd2 connection ports are under the driver side dash and can be visible without removing any panels. On some chrysler Daimler vehicles you do have to remove a panel to access this service port. If its not located under the dash then it will be located under the hood on the driver side and be capped off and labeled obd2 scan tool service. Simply plug your wire in with the key on and the engine not running and read the codes from your vehicles on board computer/ecm/bcm. Hope this helps. Good luck.

hello there

it sounds like the speed limiter, there is nothing wrong with the car but the US cars have these silly limiters which will cut off the power. The Suburban will cut out at 99mph, Escaldes at 109 mph etc. the solution is to have the speed limiter removed. it's done electronically so you'll need to find a garage that can remove them.


Hope this helps, please don't forget to rate me.