For hot to change car brake lines
SOURCE: 1992 toyota Corolla Temp gauge does not work
find the wire that goes to temp sender and apply earth to it turn ignition on the temp gauge should read hot if it does replace water temp sender if gauge dose not move gauge needs replaging
SOURCE: 2000 Toyota Corolla Vibrates
try giving a good tune up gas filter cap, rotor,wires,plugs,should feel a dramatic change
SOURCE: How do I remove brake drum on 2005 toyota corolla
Under normal circumstances, the drum should slide right off once the wheel is removed.
If you have built up rust holding it on, there are two threaded holes near the center of the drum to aid in removal.
Insert two 12mm bolts into the holes and, while adding plenty of lubricant, turn the bolts in even amounts until they push the drum off.
Be sure to keep them lubed, as they will strip out easily if not.
If you have aftermarket drums without the holes or the screwholes are stripped out, smacking the face of the drum with a dead blow hammer will help free it up, but takes much longer for success.
SOURCE: 1994 toyota corolla brake lights won't turn off
Thanks for choosing FixYa and welcome. You need to check the brake switch. Your brake pedal contacts the brake switch when it is pressed down. There is a small button on the brake switch that activates the lights. It may be stuck or broke. Try to loosen the button first. If it won't, buy another one. They only cost a few dollars.
SOURCE: what's the spark plug gap for a toyota corolla 1.6 1992
If you are using iridium plugs or bosch supper 4 ytou don't usually need to mess with the gap. Standard plugs should be set at 0.032"
100 views
Usually answered in minutes!
×