The gas gauge and the temp. gauge isn't working my power mirrors stopped working. other than that my car runs great.
You cannot reset it you have to replace the instrument cluster. unfortuneatly that is a very common problem.
You need to test your fuses. Go through with a tester and test each one. Verify you haven't lost your ground straps running from the back of your block to the firewall.
SOURCE: 01 chevy impala. power mirrors and gas gauge not working
Check all fuses and relays. As far as the gas gauge, you may need a new fuel pump, fuel pump relay, or the float on the fuel pump is loose or came off from ear and tear.The mirrors: check the fuses; also, check, or have the button panel in the door checked to ensure the connection are secure. May need a new switch for the mirrors. I am not familiar with this vehicle; but this is what I suggest doing to solve the issues.
SOURCE: gauges not working properly
Hello, Last year General Motors lost a lawsuit about the instrument panels in 2002 to 2005 trucks. The following website contains all the information about this lawsuit settlement.
http://www.speedometersettlement.com/
This impacts the entire gauge cluster in your vehicle.
I have the same year and model as yours and my speedo is never accurate and the tach always read 6000.
The issue is the metal bearings that the gauge meter movements use. The bearings are getting dry which impedes the meter movement.
SOURCE: Insturment cluster stops working All gauges plus
get onto ebay go to cluster repair and buy a stepper motor repair kit 7 stepper motors in my 2003 k2500hd 10 new dash lights and desolding wire.instructions came with it cost about 80 bucks .old stepper motor no xc5 168. new stepper motors x25 168.lifetime warranty. a little bit tricky but well worth the effort
SOURCE: The cluster gauges on a
i had this happen to my base model 1984 el camino (previous owner installed the ss guage panel because he wanted the tach).. i had gotten my transmission rebuilt then 2 days later as im heading to school i realize my gas guage, tach, and voltmeter werent moving.. i checked the fuse, tried everything i could to fix it... ended up being a corroded wire running along the transmission... so yeah, check the fuse labelled "gauges".. i the fuse is fine then have it checked by a repair shop unless you can get to the wiring yourself
466 views
Usually answered in minutes!
×