Describe your 2004 Chrysler Town &

Check the fuse and relay for the Front Blower. You can swap front the back to test the relay.

Fuse Box Diagram Chrysler Town & Country (2001-2007)

https://fuse-box.info > chrysler > chrysler-town-country...
Fuse box diagram (location and assignment of electrical fuses and relays) for Chrysler Town & Country (Voyager) (2001, 2002, 2003, 2004, 2005, 2006, 2007).
You visited this page on 29/01/22.

• 
  

  Fuse Box Diagram Chrysler

  https://fuse-box.info > Home > Chrysler
  Fuse box diagram (location and assignment of electrical fuses and relays) for Chrysler Town & Country (Voyager) (2001, 2002, 2003, 2004, 2005, 2006, 2007).

Chrysler vehicles are notorious for the blower motor resistor going out. If your Town & Country has automatic climate control use a SMP RU399, else use an SMP RU362 for the front resistor and a SMP RU490 for the rear. They are generally located on top of the blower motor/wheel assemblies.

chrysler vehicles are known for the blower motor resistor going out, it is located on the blower box either behind or below the glove box. hope this helps

do your head lights come on as well?

Have you checked for power at your blower motor connector itself? A simple 12 volt test light can be used for this. If there's no power then check all your fuses.

most of the time the resistor is located downwind of the blower motor so it should be not to fao from the blower motor in the right rear of the van behind the quater trim panel which is the hvac unit is located

you will need to start by checking fuse,then power to motor,then blower motor resistor

all speeds?? get to the blower and rap on it, hammer, wrench, foot. if it starts working, its worn out, replace it.

Try disconnecting battery, then remove connector on BCM (body control module) and spray all contacts well with contact cleaner, re-attach, then hook-up battery, and try again. Not 100% cure all the time, but has been known to help from time to time, and very inexpensive to try.

first i will do to change the blower motor resistor and see what happen it is near the blower motor and see if any wires burned out