Location of wiper motor control module on 2003 crown victoria

SOURCE: Where is the fuse panel on a 1985 Ford Crown Vic located?

Local Ford dealership service department provide answer on location of the fuse panel. Fuse panel is located directly under the steering column. The cover panel is held by two screws and the power antenna swithch locking ring must be removed.

thank you all for you assistance,

SOURCE: fuse box diagram

Locations In Case this Picture Doen not SHOW UP FOR YA --
WIPER Fuse ok Lookin at the box with the Round Circle In TOP RIGHT Corner Wiper is Number 2 Bottom from That Circle would be 2nd one from right Suppose to Be a 30 amp fuse Hopin this Helps Ya If so Please RATE Me AS High as You feel I Dererve Thank You and Good Luck with the CROWN VIC
Notes

SOURCE: crown victoria window motor replacement

remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.

SOURCE: 2005 Crown Vic climat contr fan not working Fuses good Motor good

does it have a digital control panel? As this uses an electronic blower speed controller located at the engine compartment (rear engine block) fix on ac phlenum try to shake the connector or wire while the system is on.

Duane Wong

• 6826 Answers
• Posted on Oct 28, 2010

SOURCE: ware is the wiper module

Follow the Dark Blue/White wire or Brown/White wire from the Multifunction Switch to the wiper module according to the schematic.
Also, one can trace the wires from the windshield wiper motor to the wiper module by peeling away the wiring loom and looking for a Yellow/Red wire that leads to the module.
---
Windshield Wiper Motor Removal & Installation To Remove:

1. Remove the mounting arm and pivot shaft assembly.
2. Remove the windshield wiper motor cover.
3. Remove the clip.
4. Disconnect wiper transmission linkage.
5. Remove the bolts.
6. Remove the motor.

1. Position the wiper motor.
2. Install bolts. Tighten to 10 Nm (89 in. lbs.).
3. Connect wiper transmission linkage.
4. Install clip.
5. Install wiper motor cover.
6. Install mounting and pivot shaft assembly.