1996 Chevrolet Blazer Logo

Related Topics:

A
Anonymous Posted on Sep 13, 2014

Schematic for fuel system 1996 chevy blazer

Replace gas tank and fuel lines 1996 chevy blazer

5 Related Answers

mikehumble

  • 124 Answers
  • Posted on Dec 08, 2008

SOURCE: 2002 chevy blazer fuel pump (4 door)

yes you have to drop the tank. you will also need a fuel line tool to unhook the fuel lines. before you drop the tank see if tou can reach and wiggle the electrical connection on the top of the tank. these pumps have a pigtail issue. please rate

Ad

Anonymous

  • 295 Answers
  • Posted on Mar 18, 2009

SOURCE: HELP! HELP! SOMEONE PLEASE ! 2001 chevy blazer fuel problems

I would check to be on the safe side the fuel filter is going in the right direction. The arrow is pointing towards the engine away from the fuel tank, Then you need to make sure the fuel pump wiring connections are good contact and did not come loose when driving.

farbeonddriv

  • 1 Answer
  • Posted on Apr 07, 2009

SOURCE: blazer runs awful....

i had the same issue after having replaced the egr sensor and the O2 sensors turns out the fuel pump was bad.

Anonymous

  • 34 Answers
  • Posted on Jun 02, 2009

SOURCE: Chevy Blazer won't start; fuel pump needs replacing

Before spending several hundres on a fuel pump, I recommend doing a fuel pressure test. You can get a test gauge pretty cheap at a parts store. If the pump is junk, you raise the truck, lower the fuel tank, unplug the electronics from the pump at the top of the tank, then with a hammer and flat head scrwedrive, gently tap the lock ring in a counter clockwise direction until it pops off. Pull the pump assembly out and install the new one. Reverse directions to install.

cy schousboe

  • 2002 Answers
  • Posted on Dec 02, 2009

SOURCE: need diagram of fuel system for 1995 chevy s10

The only way I know of to get the diagram you are looking for is to acquire a "build book". Even dealer service manuals don't have this diagram. I got one from faxonautoliterature for $49 plus shipping. A better bet would be to find a spot on either end of the leak where you can work on it easily and work from there. Hope this helps.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Schematic for 1996 chevy blazer fuel tank

Get a Haynes or Chiltons Manual for diagrams and instructions for your vehicle.
0helpful
2answers

1996 Chevy Blazer won't start unless i add gas to the carb. Turns over fine but won't start.

You could try changeing the fuel filter its located under the drivers door mounted to the frame in the fuel line . But the most likely thing that it could be is the fuel pump. You could check fuse # 9 its a 20 AMP in the fuse box that feeds the relay located in the glove box but on this vehicle even if the relay wore bad the vehicle would still start it would just crank for a longer time . the fuel pump has a beck up power supply also feed from fuse #9 that runs through the oil pressure sending unit. So if its not the fuse its the pump or a bad connection at the pump and that is located inside the fuel tank witch needs to be droped to replace the fuel pumpGood luck with it but this is a common issue with blazers
0helpful
1answer

1996 chevy blazer can you replace just the fuel pump without changing the whole module

No its a unit and its in the fuel tank witch means that the tank has to come out and you might as well change everything involved with it because its not an easy job and you don't want to have to do it again 6 mounths down the road to replace a bad line or some other part that could have been done for an extra 30 dollars when it was apart
0helpful
1answer

Changing fuel pump for 1996 chevy blazer

Whats the problem? To change the pump you must drop down your gas tank. Make sure it is as empty as you can get it though! Once the tank is dropped you need to twist the retainer ring (usually with a screwdriver, and make sure its got some tape on it so it wont spark. then you can replace your pump.
0helpful
1answer

Replacing a 2000 chevy blazer fuel pump and help

the gas tank will be needed to be dropped to gain access to the top of the tank to remove the sender with the attaching fuel pump on it. basicly you disconnect all lines first then the tank straps. the tank will be lighter if no fuel is in it too
0helpful
1answer

I have a 1996 chevy blazer replaced the fuel and

No, the fuel pressure valve may be stuck open so that the fuel pressure is too low when you start up, but the pump keeps up after the engine starts...
The fuel pressure valve is draining the fuel back into the fuel tank when the Blazer is parked.


0helpful
1answer

Tied to solve problem why 1996 chevy Blazer won't start

They should be on seperate circuits. Tyour key on and ck to see if you have any fuel flow. Fuel pumps in tanks do **** out. chk to see if you have any fuel flow by loosening a fluel line. No fuel, no pump. good luck
11helpful
2answers

2002 chevy blazer fuel pump (4 door)

yes you have to drop the tank. you will also need a fuel line tool to unhook the fuel lines. before you drop the tank see if tou can reach and wiggle the electrical connection on the top of the tank. these pumps have a pigtail issue. please rate
0helpful
2answers

1996 chevy blazer

you may want to check fuel pressure possibly fuel pump try banging on the gas tank with a mallet while someone tries to start the car if it is a fuel pump you may be able to get it started but pump will still need to be replaced
Not finding what you are looking for?

220 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...