SOURCE: key fob will not undo
If you don't have one that works for the vehicle now, you'll have to take it to your local dealer to have it programmed to the vehicle. Some will charge for this, some will do it at no charge.
If you do have a remote that is programmed and working for the vehicle, then the following steps will allow you to program another remote:
1. Enter vehicle and close all doors.
2. Put seatbelt on (or clip it into the buckle) to shut the warning buzzer off.
3. Put key in ignition, turn to run position but don't start it.
4. Press and hold the unlock button on the working key fob and hold for 4 seconds, then also press the panic button.
5. Release both buttons and you should hear a single chime to indicate it is in program mode. You have 30 seconds after the chime to program any additional remotes you want to program.
6. Press and release both the unlock and lock buttons simultaneously on the remote you are programming. You should hear another single chime.
7. Within 4 seconds after hearing the chime, press either lock or unlock button on remote that you are programming.
SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock
For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.
SOURCE: 2005 Chrysler Grand Voyager. Central locking
the body control module may need a software update..check with your local dealer
SOURCE: fob wont work the locks
I have done this procedure for my peugeot 307, but you can give it a try for your Pug expert and let me know if it works.
Disconnect the battery for 5 minutes then after connecting the battery perform the following steps
1. Turn the Ignition switch to the ON position using your key.
2. Press the LOCK button for 10 seconds. It will set your ECU in programming mode.
3. Remove the key and wait for 10 seconds.
4. Press the buttons on the key repetedly for operation (lock und unlock doors) to synchronise the key signals.
5. Again turn the ignition on and start the engine.
6. Turn the ignition OFF
If fails in step 4, then disconnect the battery and reconnect it and wait about 10 minutes to check the remote. Some new ecu units synchronises itselfs if you disconnect the battery while in programiing mode.
SOURCE: key fob wont work on my Peugeot Expert
Try this, press and hold the large button on your key fob,after 20 seconds press the small button while still pressing the large one, the led light will go out and will reset your remote. It worked for me. ray1297
446 views
Usually answered in minutes!
×