Need to change the battery - how do we open the key?
For better result download the pdf file
2003 2008 Isuzu Holden Rodeo Workshop Service Repair Manual Download
SOURCE: how to change oil transmission isuzu rodeo 2003
There are two drain plugs on the bottom of the pan. remove the lower one to drain the trans fluid. To refill, use a pump and pump the fluid into the upper drain plug until it seeps out and re-install the plug, similar to refilling a manual trans.
Once this is done, Start the vehicle and run it for about 3 minutes, shifting through all gears (do not drive vehicle Remove the upper drain plug and let any excess fluid drain out. Done. This is as per Mitchell OnDemand.
SOURCE: where is air cabin filter located on 99 isuzu rodeo?
its usually behind the glove compartment in the blower box. you will have to pull the GB door down all the way to access it
SOURCE: 2001 isuzu rodeo has intermittent starting problems
check battery cables & terminals for tightness & corrosion.also check at starter.check starter bolts & actual starter for looseness.if no problems found your starter may be on its way out.next time it happens hit starter with hammer or heavy object if it starts right up get ready to replace it.good luck
SOURCE: 2004 holden rodeo, remote control key wont lock/unlock doors
try putting key in ignition turn to on position
then press lock & unlock several times slowly if door locks cycle up & down after 1st press it lost code and is now resynconised.
now try remote with all doors closed and key out of ignition
if this dont work need to register key(program)back into system which dealer must do with Tech2 if round heart shapped remote
SOURCE: Crank Sensor in 94 Isuzu Rodeo
it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)
139 views
Usually answered in minutes!
×