My mighty max has a hydrolic clutch, pedal goes to the floor befor i can shift, even then it is hard to get in gear, all gears. how do i fix this?

SOURCE: Hydrolic Clutch only works intermittently.

buy new
clutch kit,bushings might be worn out...

SOURCE: can t shift gears

loosen the bleed screw.Then check if you can press the pedal down.If you can you have to change the clutch Assembly.If you still find it hard to depress then the master cylinder needs to be replaced.Hope this was useful.

SOURCE: hydrolic clutche

try getting new boot, then bleeding, just like brakes, hopefully you just got air in the line, i think the bleeder screw is close to the line going into the tranny bell housing, driver side

SOURCE: clutch pedal stuck up

You have to replace the Slave Cyl. when you put on the new one you have to bleed it ..To get the air out of the new line.

SOURCE: are all the clutches on

Hi,

Not usually these models all had hydraulic master cylinders for the clutch, if there is a master cylinder next to the brake master cylinder then that will be the clutch master cylinder and it will be hydraulic.

Thanks

Jason