1992 Toyota Corolla Logo

Related Topics:

A
Anonymous Posted on Sep 11, 2014

Bleed brakes on 92 Toyota corolla

How to bleed brakes on 92 Toyota corolla

1 Answer

metman

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

  • Toyota Expert 471 Answers
  • Posted on Sep 12, 2014
metman
Toyota Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Joined: Mar 17, 2010
Answers
471
Questions
0
Helped
119924
Points
790

Do a search on youtube and you will be able to watch a video of how to do this.

5 Related Answers

Anonymous

  • 149 Answers
  • Posted on Jul 15, 2008

SOURCE: brakes system for 2001 toyota corolla

it should have disk brakes all round but shoes for the hand brake on the rear. unless you have the"poverty pack" it may just have shoes on the rear.....

Ad

Anonymous

  • 1392 Answers
  • Posted on Jun 10, 2009

SOURCE: toyota yaris brakes how do you bleed the brakes on a toyota yaris

have someone pump the pedal and hold it, then you work from the right rear, left rear, right front, left front, while the person pumps and holds several times at each wheel.

mecanica03

ROBERT GARCIA

  • 926 Answers
  • Posted on Jul 14, 2009

SOURCE: bleed brakes on 2003 toyota corolla

i try to help you, firts refill brake fluid container,open purge valve in one wheel front only,wait few minutes when drops fluid, close this valve and open other wheel, same procedure, finally repeat this in each 4 wheels

Anonymous

  • 333 Answers
  • Posted on Oct 17, 2009

SOURCE: How do I remove brake drum on 2005 toyota corolla

Under normal circumstances, the drum should slide right off once the wheel is removed.

If you have built up rust holding it on, there are two threaded holes near the center of the drum to aid in removal.
Insert two 12mm bolts into the holes and, while adding plenty of lubricant, turn the bolts in even amounts until they push the drum off.
Be sure to keep them lubed, as they will strip out easily if not.

If you have aftermarket drums without the holes or the screwholes are stripped out, smacking the face of the drum with a dead blow hammer will help free it up, but takes much longer for success.

Anonymous

  • 248 Answers
  • Posted on Feb 05, 2011

SOURCE: How do I replace "front brakes" toyota corolla

Replacing front disc brakes is a relatively easy task. The attached link will walk you through the steps:

http://www.ehow.com/how_4520110_replace-front-disc-brakes-toyota.html

Please remeber to rate this solution. Thanks!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Spongey brakes 2009 corolla, replaced front pads

Hi, you may have air on the brake lines. Try bleeding the front brakes. The process should be found online
0helpful
1answer

After I change the brakes 95 toyota corolla the brake doesn't work. what is the problem? And how do I fix it?

Pump the break then bleed each leg, make sure there is hydrolic in the master brake fluid.
0helpful
1answer

Low .brakes pedal

The first thing i would check is the brake fluid level. If it is full I would attempt to bleed the brakes. For some simple instructions on bleeding brakes, please go here.
0helpful
1answer

2006 toyota camry have to press the pedal almst to the floor or pump it to have brakes

I had a similar problem with my 1996 Toyota Corolla. It sounds like you need to bleed the brake lines. If your brake fluid was recently low, or if you had a leak in your brake lines this could be necessary. A step-by-step guide to the process is listed here: How to bleed a break line
0helpful
1answer

92 toyoto corolla, 3rd brake light,tail light and stop lights stay on after i turn the other lights on.

Your brake light switch is stuck. It is located under the dash, near the top of the brake pedal. Replace it with a new one.
0helpful
1answer

Corolla 2000 brakes, I did change master cylinder,

System may have air in it bleed from farthest wheel to closest.
If rear shoes are out of adjustment re adjust them
Possible but most pads require a "bedding in" 20 stops 50 to25mph or so.
0helpful
1answer
1helpful
1answer

Bleed brakes on 2003 toyota corolla

i try to help you, firts refill brake fluid container,open purge valve in one wheel front only,wait few minutes when drops fluid, close this valve and open other wheel, same procedure, finally repeat this in each 4 wheels
Not finding what you are looking for?

256 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...