Removing ignition switch on 94 dodge caravan
Here you go joe.a guide to do the job. Repair Guides Steering Ignition Switch And Lock Cylinder Assembly...
SOURCE: dodge caravan sliding doors
First, keep in mind that as you begin to remove these doors you run the risk of causing serious scratches to the paint and glass, so put some masking tape and/or plastic sheeting around both sides of the door (rear quarter panel and rear glass, front door and front door glass)
I would get a Haynes repair guide since that's what I have to work from and it will tell you step by step with pictures, what to do. It's not hard, but you need to get all of the attach points unhooked to be successful. Suggest you have a helper working with you to keep the door steady.
SOURCE: remove the rear brake drum on 2004 Dodge Caraven
No just make sure your emergency cable is off and take a large hammer an hit it around the edge or corner lightly and spin at the same time also try pulling with your other hand as you spin this is a technique all mechanics use its very unlikely that you will have to loosen up the shoes with a brake spoon.REMEMBER THE OUTER ROUNDED EDGE ONLY WHERE ITS THE THICKIST.
SOURCE: how to remove interior door panel on a 1997 caravan with ower windowq
Start by removing the negative battery cable from the battery. Then locate and remove the screws that hold the interior door handles in place (they may be hidden by snap in, or snap on covers). Once you have removed the interior door handles, disconnect the wire clips that go to your window and door lock controls.
I personally use a small pry bar to remove the interior door panel; it is held in by plastic snap clips. Try to get as close to, or directly under the snap clips as possible with your pry bar to prevent them from tearing out of the door panel. Once you have released the snap clips, pull the panel upward to remove it. Install in reverse.
I hope this information helps you, and I wish you luck on your repair.
SOURCE: how do I remove the passenger side power mirror on 98 caravan?
If you're lucky, on the inside of the door, will be a triangular panel
right behind the mirror that you can pop off. If you're not as lucky
and it's one piece or the panel is blocked by the door panel, you'll
need to remove the door panel to change it.
On the inside trim,
you can remove screws (these screws may be covered by filler pieces or
may be visible, or they may require you pry a plastic piece off that
covers the screws) that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls. Then you can remove the bolts
holding the mirror onto the door
SOURCE: Can't remove water pump from 2007 Dodge Grand -
you must undo the three pully bolts turn the pully so it slips behind the mounting flange , then you should be able to wiggle it out , if it still hangs on frame you a long pry bar and push between frame and crankshaft bolt just hard enough to move engine slightly, this will definitly work and repeat to install. PS use a little RTV silicon to hold seal on new pump.
310 views
Usually answered in minutes!
×