2010 Jeep Patriot Logo
A
Anonymous Posted on Sep 09, 2014

2010 jeep patriot traction light comes on especially when making left turn and lagging

Skid control, or traction light??? comes on when barely making turn then has no power to go

1 Answer

_-__-___-_

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Jeep Master 20,706 Answers
  • Posted on Sep 10, 2014
_-__-___-_
Jeep Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Apr 06, 2013
Answers
20706
Questions
2
Helped
6802398
Points
57965

Where are the controls set at for 4wd?
and is this dirt or pavement....???

5 Related Answers

Anonymous

  • 512 Answers
  • Posted on Jan 04, 2009

SOURCE: Jeep Patriot heater fan makes noise

the blower motor is located under the dash on the passenger side of the dash.a bracket with 1 screw and 3 other screws hold the motor in the heater box. remove them amd the electrical connector and the motor an be removed

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 16, 2009

SOURCE: 2005 Jeep Grand Cherokee (HEMI) Service Electric Brake System

Problem is a faulty Steering Angle Sensor (part of Steering Module) located in steering column ...replacement part $600.00.

Anonymous

  • 114 Answers
  • Posted on May 07, 2009

SOURCE: ABS TURN LIGHTS COME ON

need to get abs codes read. it will tell you what wheel to look at.
1.bad wheel bearing, sensor is part of bearing.
2.broken wires to sensor.
3.traction control part of abs

Anonymous

  • 1 Answer
  • Posted on Oct 13, 2009

SOURCE: jeep 2008 patriot esp light on Malfunction

Check under drivers door sill step. There is a spice I believe the wires are red or pink in color. The splice will be wrapped in black hockey tape looking stuff. Peel the the hockey tape stuff off and you will find that this splice is corroded and not making contact anymore. You can repair this splice and your problems will be fixed. Be sure to use some good heat shrink on your repair to prevent from happening again.

Anonymous

  • 2382 Answers
  • Posted on Oct 24, 2010

SOURCE: I had the ABS light

Hi,the traction control light coming up means there is a fault detected in the system and a scan tool will be required to learn what fault has been detected. Possible steering angle sensor, wheel speed sensor or brake pressure sensor since the light comes up when making turns or when backing up. Faults are to be checked and proper diagnostic procedures carried out before parts replacement remedies.....

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

2016 Jeep Patriot ABS light and traction control light came on recently had tires rotated on new jeep for the first time drives well P

The abs and traction control use the same sensor system get the codes read to see which wheel speed sensor has thrown a fault
0helpful
2answers

My jeep has no power and the traction light comes on with the etc light when I drive it.

run the fault codes , fix the problem with the traction system and then the limp mode will be deactivated
0helpful
1answer

Traction control light flashes

mine does it any time i drive funny, drive on gravel or ?
it's normal
what is not normal, is if it stays on.
what does jeep pulls at 50 mean.??????????????
are what is pulling,???????????
do you mean the car pulls to the left or right ? steering wheel steady/.?
brakes pull? while braking, or brakes pull full time?
if the lamp is on , on flat hard dry pavement, the car needs service.
the operators guide tells you all this, read the pages?. on traction controls.???? do so, read the whole thing.

the lamp can mean:
1: car was out of control and i made corrections.
2: system failure.

connect a scan tool see if there are DTCs on the system.s


0helpful
1answer

Traction control flashes

double posted and still no details.
define pulls.
what pulls and when.
we just dont know
why not get the car serviced,?
have a real mech, drive care and see if something pulls.
and why.
why not.
0helpful
1answer

Traction control light flashes and truck pulls

Take it back to the yahoo who messed it up they sound like they sabotaged your truck I\'d go back ask for the owner explain what happened if they care about there cust you will b handled
0helpful
1answer

Traction control light stays on and truck want go

join a liberty forum and post there find by googleing jeep liberty forums
2helpful
1answer

How do I know when my Traction control is working on my 2010 Touring? We live in Northeastern Ohio and I seem to be sliding alot when I go to stop and I'm not speeding. Thank You!

A good way of testing the traction control is to stop on a slippery road and then take off fast as to spin the wheels there when wheels start to spin the traction should activate and stop the spinning wheels you may hear it kick inand a light on the dash will say trac active or trac on, as far as sliding when stopping this is where the abs would come in,abs anti skid brake system, this system when you are braking would release the sliding or skidding wheel and you would felt it in the brake pedal, good luck, hope this helps.
Not finding what you are looking for?

1,328 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...