Need to know location for vent emissions valve and solenoid on 2007 montana or a diagram with location
SOURCE: Changing the starter solenoid on a 2000 Pontiac Montana
On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.
SOURCE: pontiac montana oil pan bolt diagram for removal
If all the bolts are off, then the gasket is holding the oil pan in place and your going to have to tap it with a mallet, Not a hammer but a mallet so you don not damage the oil pan. Good luck and hope this helps.
SOURCE: 2000 pontiac montana air conditioner driver side
That is correct, the air blend door actuator. "flapper valve" may need to be replaced or cleaned and free from binding up. Good luck and hope this helps. If there is an Auto Zone in your area, they can order the part you need and give you the step by step instructions to removing the old actuator and replacing it if it's damaged. Good luck and keep me posted, be glad to help.
SOURCE: Bad Evap Vent Solenoid
On the passenger side of the car there it a canister next to the gas tank (right infront of the rear wheel) it's right there. You don't need to pull the wheels to access it.
438 views
Usually answered in minutes!
×