1999 Honda Accord Logo

Related Topics:

A
Anonymous Posted on Sep 08, 2014

Cables connected to kick starter

Kick starter showing light at asc but not cranking, it is a manual car. it starts when I push it forward and releases the gear.

1 Answer

Joaquin A Barahona

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

  • Honda Expert 133 Answers
  • Posted on Sep 09, 2014
 Joaquin A Barahona
Honda Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Jul 02, 2010
Answers
133
Questions
0
Helped
105607
Points
250

I am not sure what a kick starter is and what "light at asc" is. I think it would be a good idea to check the starter motor

5 Related Answers

c17hydro

Greg Bernett

  • 2993 Answers
  • Posted on Mar 13, 2009

SOURCE: starter wont turn when i turn the key but will

Bad starter solenoid

Ad

Anonymous

  • 202 Answers
  • Posted on May 01, 2009

SOURCE: When I drive my car, it kicks. Also when I switch gears and reverse it will kick, what is wrong with it?

check the engine mount.

Anonymous

  • 740 Answers
  • Posted on Jun 17, 2009

SOURCE: had problems with my 2003 honda accord,it cudnt

If the ignition on this car is ever disconnect then the key needs to be programmed. This vehicle has a key recognition system. This is an anti theft system. The new ignition needs to be programmed by a computer. You may have to take it to trhe dealer and pay them to do it. They are some regular shop that can do it, but I will recommend the HONDA dealer hands down. Good luck and thanks for using FIX YA

Anonymous

  • 138 Answers
  • Posted on Jul 25, 2009

SOURCE: when i use kick down the car jerkin and dont pull away ,is fine w

Check tranny fluid when engine is hot.(automatic) Probably vacuum powered so check hose to trans for holes or leaks. If manual kickdown, linkage should be adjusted.

YellowNo5

Jeremy

  • 268 Answers
  • Posted on Sep 23, 2009

SOURCE: car cranks then an hour later won't crank

Battery or starter. Sometimes the battery will have enough power to activate fuel pump and dash lights but not enough to turn starter.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

125 4 speed manual kick starter has stopped engaging.

You posted to the category 'Cars and Trucks'. You have a car that needs kick starting, like an old Heinkel, Isetta or a Zundapp? Very neat.

All questions need 'year make model' as the first 3 words!

There are over 10,000 categories to choose from listed by 'make year model'.

Take it apart, find the part that snapped. A kick starter has a return spring and a pawl that engages with the crankshaft to turn the engine.

Kickstart not engaging

Unofficial Royal Enfield Community Forum https://forum.classicmotorworks.com > ...
Jun 8, 2021 · 15 posts · 7 authors
Re: Kickstart not engaging Just check the pinch bolt on the kick starter lever to make sure it's good and tight on the splines. Now get out ...

Help! kickstart does not engage properly

KDXRIDER.NET https://kdxrider.net > ... > KDX General Q&A
Dec 8, 2018 - the kick starter is slightly twisted but not enough to make it engage this low down. it engages around 9 o clock. if you look at it as if its a clock... leaving ...

19 posts · hello, ive got a problem with my kickstart. whenever i go to kick it over it doesnt engage ...
Kick start stuck
9 posts
May 4, 2020
Kick Starter Lever Won't Return
19 posts
Dec 16, 2014
Kick starter not engaging
3 posts
Dec 7, 2018
Kick starter won't engage until past half way?
19 posts
Sep 15, 2020
More results from kdxrider.net

Kick starter not engaging??

lilHonda.com https://lilhonda.com > ... > Tech Area
I have both a CT-70 and a z50 and they both have a problem where if I kick it over hard sometimes it will not "engage" and it will just slip.

Kickstarter won't engage properly

Yamaha Blaster Forum https://www.blasterforum.com > ... > Engine
Jul 31, 2014 - "make sure the clip sits in it's housing in the crank. Make sure the stop is in the right location, and then wind the coiled spring clockwise ...
..
0helpful
1answer

Where is the starter relay on a 1995 Mitsubishi Mighty Max PU

It sounds more like you have a bad connection somewhere or possibly a weak battery.
0helpful
1answer

Misabishi verada, all lights horn ect work but wont kick over

You need to find out id your ign switch is sending 12v electrical to the starter.. There ia large post with the positive battery cable attached to it and a small post which is the wire from the ign switch connects.. run a wire from a postive source like the battery cable to the small post.. if the engine cranks you will know the starter is good and its not getting a 12 single from the ign switch. Post a comment and let us know what you find.
0helpful
1answer

Bcm grand cherokee

05 GC,
kick starter, you a jeep with a kick starter. wow..... gotta see that.
1helpful
2answers

Z3 starter

1st thought is. If you can get at the starter motor with a small hammer,or something,have somone hold the key on "start" and tap the motor,if it cranks ,it's a starter brush broblem.
0helpful
1answer

My battery went dead and i replaced it and when i re-installed it the alarm went off and it wont start now

Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.
the valet switch is by driver side kick panel look for small button may be stuck in wire harness to hide
0helpful
3answers

I have a 2003 Galant GTZ 3.0L . batery is good and all the lights work. when I try to start the car all I hear is single click. the car does not start. I cleaned the batery cables and still the same, no...

if you've tested your battery and know you have a good connection at the terminals that one click sound is a bad starter. you may wish to attempt to tap on it while cranking to try to get it to start. if you do crawl under your car use jack stands to hold the car in the air. never leave a losd on the jack. safety first. if this was helpful please leave positive rating.
1helpful
1answer

Need a wiring diagram that will assist in installing a remote car starter for a 2003 4x4 kia sorento

12 VOLT CONSTANT GREEN (+) and BLUE (+) IGNITION SWITCH HARNESS STARTER RED (+) IGNITION SWITCH HARNESS STARTER 2 N/A IGNITION 1 YELLOW (+) IGNITION SWITCH HARNESS IGNITION 2 N/A IGNITION 3 N/A ACCESSORY/HEATER BLOWER 1 ORANGE (+) IGNITION SWITCH HARNESS ACCESSORY/HEATER BLOWER 2 WHITE (+) IGNITION SWITCH HARNESS KEYSENSE N/A PARKING LIGHTS ( - ) WHITE (-) @ HEADLIGHT SWITCH PARKING LIGHTS ( + ) RED/BLACK (+) @ DIMMER SWITCH POWER LOCK BLUE (TYPE B) IN DRIVERS KICK PANEL, at DOOR HARNESS POWER UNLOCK WHITE (TYPE B) IN DRIVERS KICK PANEL, at DOOR HARNESS LOCK MOTOR WIRE WHITE (+) IN DRIVERS KICK, at DOOR HARNESS DOOR TRIGGER RED/BLACK (-) DRIVER KICK PANEL HIGH IN BLUE PLUG DOMELIGHT SUPERVISION USE DOOR TRIGGER, Requires Part #775 Relay TRUNK RELEASE RED/ORANGE ( - ), Requires Part #775 Relay IN DRIVERS KICK PANEL, harness to rear of vehicle SLIDING POWER DOOR N/A HORN BLUE/BLACK ( - ) @ STEERING COLUMN HARNESS TACH RED (-) @ COIL PACK WAIT TO START LIGHT N/A BRAKE WHITE ( + ) @ SWITCH ABOVE BRAKE PEDAL FACTORY ALARM DISARM ORANGE (-) IN DRIVERS KICK PANEL
1helpful
1answer

92 Toronado won't start.

GO TO THE STARTER AND CHECK THE S TERMINAL(SMALL WIRE GOING TO SOLENOID) FOR POWER W/THE KEY IS CRANKED.IF NO POWER THERE THAN THE SECURITY SYSTEM MAY HAVE A PROBLEM.IF YOUR IGNITION KEY HAS A BLACK CHIP IN IT THAT IS FOR THE SECURITY SYSTEM.THE IGNITION LOCK CYLINDER HAS 2 WIRES COMING OFF IT INSIDE THE STEERING COLLUM.THOSE WIRES BREAK QUITE OFTEN,THEN THE STARTER WON'T CRANK
Not finding what you are looking for?

110 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...