Where motor for sunroof top 1999 cadillac

All question need full 'year make model' in real words. A Caddy Platinum is a Gold Card for Golf Caddies.

Presumably you mean a 2016 Cadillac Escalade Platinum Edition?

The wind damper, or rather wind deflector pops up at the front of the sunroof to deflect air over the top to stop a drumming noise. Press the deflector down when you are doing 70mph. It has no bearing on leaks. Your problem is almost certainly blocked sunroof drains. The water doesn't drain, pools in the tracks and overflows.

How to clear the sunroof drain tubes

Cadillac Owners Forum https://www.cadillacforums.com > threads > how-to-cl...
Mar 14, 2010 - Wait - there's more. To clean the drain tubes it was suggested using .080 weedwacker string to rod them out. Two problems here. The first is ...

Sunroof drains cause water enter rear cargo area
Jul 7, 2017
Rear sunroof drains - Cadillac Owners Forum
Jul 14, 2020
Sunroof drain lines ' Cadillac Owners Forum
Dec 18, 2019
SRX not waterproof - BUYER BEWARE sunroof drain tubes
Mar 28, 2016
More results from www.cadillacforums.com
..

It appears to be year specific.

https://www.gmpartsdirect.com/v-2002-cadillac-deville--dts--4-6l-v8-gas/electrical--sunroof

https://www.google.com/search?q=2002+Cadillac+Deville+replacement+sunroof

And dropping the year from the Search Query.

https://www.google.com/search?q=Cadillac+Deville+replacement+sunroof

Here's a description the sun roof
Power Sunroof System Components
The power sunroof system consists of the following components:
• Sunroof module
• Sunroof switch
• Sunroof motor, with 2 hall effect sensors and limit switch
• Sunroof window
• Sunroof sunshade panel
• Power supply for the sunroof module: RAP 25 A
• Ground G402

Override
The override function is used when needing to force a closing of the sunroof window. To override the system:
Turn ignition to ON.
Rotate the sunroof switch to the close position.
Press upward.
The sunroof switch data 6 circuit, or override circuit, will become grounded at the sunroof module. As long as the sunroof module sees this input, it will continue to slide the sunroof window to close, regardless of the other sunroof switch data circuits inputs.

Is the motor receiving power? If not you have to check electrical system to locate the place that is not transmitting power. Could be a fuse/relay, switch, bad connection.

If the motor is turning and nothing happens then the drive mechanism from motor to sunroof is stripped. Not good.

Check the RAP fuse in the rear fuse box , this fuse powers the sunroof control module ! Fuse Block - Rear , Left rear of the passenger compartment, under the rear seat .
The sunroof module contains the logic for the opening and the closing of the sunroof. The sunroof motor assembly contains the reversible DC drive motor, the gear train, and the limit switch.
The sunroof module determines the sunroof motor direction based on inputs received from the overhead console sunroof switches. When the ignition switch is in the ON position or when retained accessory power (RAP) is active, voltage is applied to the sunroof module via the RAP relay. For a description and operation of the RAP system, refer to Retained Accessory Power (RAP) Description and Operation in Retained Accessory Power. The sunroof module controls the sunroof motor direction by changing the polarity of the applied voltage. The sunroof module remembers the sunroof position whenever the ignition switch is turned to the OFF position. The limit switch is used as an input to the sunroof module to indicate that the glass is fully closed, or in the comfort stop positions. The limit switch is grounded when the sunroof glass is in the fully closed or comfort stop positions, otherwise it is open.
The SLIDE CLOSE mode is initiated by moving and holding the sunroof slide switch (ROOF) forward. This applies a ground provided from the sunroof limit switch low reference circuit to the sunroof switch close vent signal input of the sunroof module. The sunroof module controls voltage to the control circuits of the sunroof motor. The sunroof motor will run until the limit switch contacts are closed. The closing of the limit switch will apply the sunroof limit switch low reference circuit to the sunroof limit switch soft stop signal circuit to the sunroof module, indicating the flush closed position has been reached. As the sunroof is approaching the close position the sunroof glass will force the wind deflector downward.
You need to have a factory scan tool hooked up an have it checked for DTC'S in the sunroof control module ! a code reader will not do this , a code reader will only check the engine codes for OBD 2 .
Important: The following must be completed before using the symptom tables.

1. Perform Diagnostic System Check - Power Sunroof in order to verify that all of the following are true:
?€¢
No DTCs are set.



?€¢
The control modules can communicate via the serial data link.


2. Review the system operation in order to familiarize yourself with the system functions. Refer to Sunroof Description and Operation

your better off taking to the dealer !

Sorry Bill but you don't the tool's or knowledge to take on this job . Control module's involved.
Which one does your vehicle have ?
Power Sunroof System Components -- CF5
The power sunroof system consists of the following components:
• Front glass control module and motor assembly
• Front sunshade control module and motor assembly
• Sunroof switch
• Front glass panel
• Front sunshade
• Power supply for the front glass control module and motor assembly logic: RAP relay
• Power supply for the power sunroof system: SUNROOF MOD fuse 40 A
Power Sunroof System Components -- C3B
The power sunroof system consists of the following components:
• Front glass control module and motor assembly
• Front sunshade control module and motor assembly
• Sunroof switch
• Front glass panel
• Front sunshade
• Rear sunshade control module and motor assembly
• Rear sunshade switch
• Rear sunshade
• Rear fixed glass panel
• Power supply for the front glass control module and motor assembly logic: RAP relay
• Power supply for the power sunroof system: SUNROOF MOD fuse 40 A

That has NEVER been an option on any cadillac since 1965 fo sure. If it was then it was some off the wall aftermarket item. If so then they need to fix it

look under the dashboard on the drivers side.there should be a chart on the inside of the box lid to tell you which fuse is where.

Sunroof relay control module 99 seville

Open the shade cover to access the sunroof from inside the car. On each side of the sunroof (driver and passenger) there is a black accordian looking cosmetic molding, toward the back side of the sunroof (rear of the car) stick your finger behind it at the top and pull you will now be able to see a T25 (torx) screw you will need to slightly loosen it on each side of the car if they are not already loose then push up on the center rear of the sunroof. you may want to have someone outside of the car to tell you the proper height, when you have the proper hight set tighten the screws then replace the molding. You are done, no more noise!