How to replace cabin filter for toyota previa 1992

SOURCE: Cabin Air Filter replacement

http://www.carspace.com/guides/Changing-Cabin-Filter-on-Toyota-RAV4-Echo-Scion-xA-and-Scion-xB

SOURCE: cabin Air Filter

Open the glove box

Remove all of the contents in the glove box

On the right side, dis-engage the rod going to the split plastic pin on the glove box door

Squeeze both other sides of the glove box to defeat the stops that keeps the glove box from falling open

Observe the box in the area vacated by letting the glove box drop down, this is the heater box

Locate a rectangular cover (approx 7 " x 2"), it is located on the face of the box; facing you.

Pull this cover out towards you, the cabin air filter is located in the tray that is connected to this rectangular cover.

This should help you replace it.

SOURCE: Installation of 2004 Toyota Avalon cabin filter

I will be happy to provide you with the instructions.

Open the glove box.

Remove all of the contents.

Observe the right side of the glove box door, you will see a black plastic thing/arm that is connected to a cylindrical device; Remove the arm from the glove box door.

After the arm is disengaged from the glove box door. squeeze the sides of the glove box towards the middle, to defeat the 2 stops that prevent the glove box from falling completely open.

Whilst squeezing the sides of the box inward, lower the glove box door down.

With a flashlight, look into the area behind the glove box. You will see a long rectangular device, this is the door/tray for the cabin air filter. Pull it out, towards you. Once it is out, you will be able to extract the dirty filter, and replace it with a new one.

This entire procedure should take you about 3 minutes. Very easy.

Thanks for choosing FIxYa for assistance. A FIxYa rating (4 blue diamonds) would be greatly appreciated! Thanks in advance.

SOURCE: 2002 Toyota Sienna cabin air filter??

Unfortunately, no.
Toyota began installing the cabin air filters in the Sienna product starting in 2003.

SOURCE: 1992 Toyota Previa van,Oil dripping onto exhaust manifold, replace head gasket? need a free manual!

The toyota previa uses a formed silicone gasket for the valve cover and the cover is held in place by metric shoulder bolts ( 10mm). The valve gasket leaks because you can't get enough preload on the bolts to re-seat the old gasket when it gets old and shrinks. The shoulder bolts only allow you to tighten the gasket enough to seat the shoulder on the bolt. If you continue to torque down the suspected bolts, you will snap the bolt off ( don't ask me how I know this ). You can either 1.)replace the old gasket with a new one or 2.) remove the existing bolts around the leak area and put in new metric bolts that do not have a shoulder. You may want to put in a small sleeve into the existing bolt hole but shorter than the thickness of the valve cover to account for the smaller diameter bolt. You can now torque down the bolt and get enough preload to seal the valve cover without removing the old gasket. Make sure you use a torque wrench ( in-lbs) or be very careful not to snap these small valve cover bolts.