SOURCE: coolant temperature sensor on 98 kia sephia
Try this link, may help.
( http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528002843d#hd1-1-1 )
SOURCE: 2000 kia sephia clutch
this is a big job for someone who is not mechanically inclined but....here it goes go buy a new clutch new tranny fluid and a haynes manual at the auto parts store your going to have to drain and drop your tranny ... BUY THE CLUTCH WITH THE TOOL theres an alignment tool needed to align the plates n bearings start by pulling off both tires, brakes and both cv axels be sure to remove the intermediate shaft from the tranny on the passenger side (should come out with the axel passenger side only) so do yourself a favor and buy an impact gun with at least 500 ft lbs torque youll need it also have handy your 14mm 17mm and 19mm impact sockets and remember this job usually runs around 1,200 bucks at firestone also DO NOT remove the bolt in the middle of the front springs under the hood just the four around it and the will pop out no prob and wont need to be clamped remove the starter behind your engine its under the oil filter also if your new to this sorta thing its gonna take you about 3 days to do it buy the impact gun if ur in a hurry look at a pawn shop have your flywheel machined its going to be accessible and it needs it hope this helps dont forget the book which you should already have bought anyway its good for your torque specs which you will also need a torque wrench for the clutch also dont crack open ur tranny this isnt a honda
SOURCE: Clutch
There is a spring on the pedal up under the dash, if this has come undone then the pedal may not be able to come back up to the normal position. The spring connects directly to the pedal and to a bracket under the dash.
SOURCE: clutch is sticking
More than likely the slave cylinder on transmission is leaking,< Hydrolic plunger that atttaches to clutch yoke > or possibly the master cylinder that operates it,< plunger sticking >. inspect them to find source of problem.If the master cylinder is low on fluid then there is a leak and slave cylinder most likely source.
SOURCE: 2001 kia sephia the clutch has dropped to the
What did you do to fix the clutch fluid loss??? if it ran dry, you need to find out where it went. You will need to replace the clutch hydraulic master and slave cylinders.
193 views
Usually answered in minutes!
×