1994 22re toyota pick up i have a eyelet with 3 brown wires going to it and cant find out where the go they come out of the engine harness by the intake and if i run them to positive side of the batte

SOURCE: Toyota starter problrm

NEED TO REPLACE STARTER.

SOURCE: 1991 Toyota Camry Automatic seatbelt harness

http://www.toyotanation.com/forum/showthread.php?t=300887
Full version about Automatic Seatbelt troubleshooting for 87-91 Camry written by Professor Oleg Turkin

SOURCE: 1994 Toyota Pick up 4X4, fuel pump only works when starter is run

The information you are requesting is copy writted in order to get it leaglly go to alldatadiy.com and buy a subscription to your car and you can view all the informantion you want. and the diagram shows all the information you need includeing a powertrain harness and look up by system not in a book.

SOURCE: i have 3 coils on

TRY THIS FRONT 3 CYLINDERS FACING YOU LEFT TO RIGHT 2 4 6 AND BACK CYLINDERS LEFT TO RIGHT 1 3 5 NOW TAKE THIS NUMBER 5 1 3 THIS IS SPARK PLUG WIRES LOCATION FROM LEFT TO RIGHT.PUT PLUGS WIRES TO THE 3 BACK CYLINDERS IN SAME ORDER YOU SEE NUMBER.LET ME KNOW WHAT HAPPENS.

SOURCE: im working on a 1986 toyota pickup 2.4l efi non

Sounds like this wire should operate the electric fuel pump through the fuel pump relay.The fuel pump relay should start the fuel pump to maintain fuel supply to the common fuel rail and any surplus fuel will be bleed back to tank by pressure control.The injector opening sequence is contolled by computer once the engine is properly timed.
If you say the engine runs for a few seconds it would indicate fuel pump or relay is not getting power to operate or fuel pump is not delivering enough pressure to feed the injectors