I just need to know what size Deep Socket i need to remove the drive axle hub nut
SOURCE: 1993 F150 4x4 w/ auto locking hubs - rotor removal
There are some special 4 tooth and hex sockets for removing the nuts inside the hubs of the truck.
YOu can find these at NAPA or maybe AutoZone or Advance. I would go to NAPA because they more than likely have it and also know something about repairing this assembly.
Ford uses Dana front end parts and NAPA has original Dana parts in stock... so it is as good as or better than original and they would have the tool for it.
Be careful and follow the procedure exactly for putting the front hubs back together.
YOU CAN RUIN THE FRONT END OF THE TRUCK IF YOU DO NOT PERFORM THIS SERVICE CORRECTLY.
And trust me... many of the idiots working in repair garages do not know how to do these older 4x4 hubs either... ask someone and read the books for the right procedure... some of the older mechanics may show you how to do it. Ask
SOURCE: i need the size of
Its 27 mm that nut is vary tight when you do this leave the brake assembly together and have someone push on the brakes when you lossen these nuts you will need a large braeker bar and mabey a short length of pipe on the end of that good luck
SOURCE: What size socket is required to remove rear axle/ hub nut on a 2003 mpv?
Deep Metric Impact- between 32 & 36 mm
Have to know those things
Google it
If you owned sockets there wouldn't be a problem
SOURCE: socket size needed to remove wheel hub on a toyota celica
How do I get on to auto parts store
259 views
Usually answered in minutes!
×