Question about 2002 Chevrolet S-10

Open Question

S-10 stalls when put in gear

Cranks fine but stalls when going forward

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 38 Answers

SOURCE: blazer cranks and idles fine

Could be alot of things. For starters i would look at the tcc solenoid. It should be located on the side of your tranny. If you unplug this and it goes into gear and runs fine then you found your problem. If this solenoid goes bad it prevents your tranny from downshifting and staying in a higher gear.

Posted on Apr 12, 2011

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car will start but put it in gear engine will die


engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com

Dec 17, 2015 | 2002 Kia Rio

1 Answer

My 2002 s-10 stalls when put in gear.


vacuum leak some where or a bad sensor in drive line some where

Sep 03, 2014 | 2002 Chevrolet S-10

1 Answer

Blazer cranks and idles fine but stalls when I put it in gear, what's wrong?


Could be alot of things. For starters i would look at the tcc solenoid. It should be located on the side of your tranny. If you unplug this and it goes into gear and runs fine then you found your problem. If this solenoid goes bad it prevents your tranny from downshifting and staying in a higher gear.

Apr 12, 2011 | 1996 Chevrolet Blazer

1 Answer

Transmission suddenly stopped shifting. It works in 1-2nd &R. Was working fine then would not go forward and would stall the engine. It was like the wheels locked up going forward only, reverse was...


The transmission solenoids are not working properly. Probably requires a transmission rebuild.
I don't think it's in the ground strap or wiring.
It's an internal problem with the transmission.

Aug 26, 2010 | 2002 Chrysler Sebring

1 Answer

Vehicle stalls when put into gear forward or reverse


first try so SPT gas teatment may sure you have a half tank of gas and then put in a little more of gas if this help change the fuel filter also check the vaccum lines and make sure they are all on and in and good conditon and also checkout the intake manifold for leaks

Apr 13, 2009 | 1998 Ford Explorer

2 Answers

Will not run in forward gears


its a common issue that once the low forward band in ford transmissions wear out that it will engage first and 2nd at the same time. of course this is not mechanically possible and the car stalls out.

your fix is to replace the transmission

Apr 10, 2009 | 1985 Ford Escort 1985 4 Door

2 Answers

CAR CUTS OFF WHEN PUT IN GEAR


if it is standerd then it is most likely your lutch try to keep your r.p.ms at the owest point you can before shifting if it is automatic it could be the pressure plate but im not an expert with automatics{yet again the change them so often that nobody really is}

Feb 26, 2009 | 1996 Dodge Caravan

Not finding what you are looking for?
2002 Chevrolet S-10 Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...