2000 Ford F150 Flareside SuperCab Logo

Related Topics:

Randy Leloux Posted on Sep 02, 2014

How do I disable anti theft system on my ford truck

Anti theft is on need to know how to take it off my truck.

5 Related Answers

Anonymous

  • 3 Answers
  • Posted on Feb 05, 2009

SOURCE: 2001 ford taurus wont start and anti-theft light is blinking

Either you may be using a key that you had copied from the original or your chip went bad in your original key. Most of cars now a days have the key censor in the key so if it is the incorrect key it will not start your car or if it does not read that chip it will not start

Ad
Keith100881

Dennis Saunders

  • 74 Answers
  • Posted on Jun 23, 2009

SOURCE: 2000 windstar anti theft system

un hook battery and wait about an hour or so and use factory key if wont fix dealer has to reset.

Anonymous

  • 308 Answers
  • Posted on Jul 09, 2009

SOURCE: how to disable 1996 ford explorer anti theft

disconnect the wire that is connected to the battery first for safety and then the anti theft wires and system.

Anonymous

  • 30 Answers
  • Posted on Oct 19, 2009

SOURCE: how do you reset the anti theft system

Try disconnecting your battery cables then wait about 10 minutes. The computer should reset itself. Reconnect the wires to the battery. It is normal for the theft light to blink about every 5 seconds when the ignition key is out or in the off position. This means the system is armed and working properly. Hope this helps. God bless!

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Dec 10, 2009

SOURCE: The anti theft sensor on the steering colum needs

The sensor is part of the ignition key lock cylinder, so the part and labor will be around $200-$300 depends on your local labor rate, the dealer must do this repair because the new lock cylinder key code must be programmed into the VATS module.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2009 Ford Flex. How to take off theft mode off 2009 Ford Flex?

Question edited for clarity and toss in some CAPS.
Question moved to model category.

You can't if by 'take off', you mean bypass or disable it. The anti theft system is there to stop what you are trying to do, drive the car without the correct credentials, key chip to the ECM. Just reset it.

How do i perform the 2009 Ford Flex anti theft reset?

Vehicle History https://www.vehiclehistory.com > questions > how-do-...
Jul 16, 2020 - Resetting the anti-theft system in Your 2009 Ford Flex is easy to do, and will take around 8 to 10 minutes of Your time. People also ask
How do I get my Ford out of anti-theft mode?"); display: inline-block; height: 24px; width: 24px;"> How do I clear my anti-theft system?"); display: inline-block; height: 24px; width: 24px;"> Can you get a car out of anti-theft mode?"); display: inline-block; height: 24px; width: 24px;"> Why is my car stuck in anti-theft mode?"); display: inline-block; height: 24px; width: 24px;"> Feedback

I have a 2009 Ford flex that's stuck in antitheft mode. What

JustAnswer https://www.justanswer.com > Ford Repair
Oct 30, 2022 - 1-Disconnect both battery cables, positive & negative. 5- Reconnect battery positive first, then negative post.

1 answer · Top answer: Hi! Welcome to JustAnswer.Thank you for contacting us for assistance with your vehicle. I'm ...
How reset anti theft alarm in 2009 ford flex - JustAnswer
Jun 3, 2014
Security system went off last night. now the 2010 ford flex
Jul 12, 2012
I have a 2009 ford flex that will not start. all of the - JustAnswer
Jan 29, 2018
My Ford flex is in anti theft mode, and it is preventing me
Jun 10, 2023
More results from www.justanswer.com

0helpful
1answer

How to disable the anit-theft system on my 2006 Ford Eclipse

If you could disable an anti-theft system, they wouldn't call it an anti-theft system. You'd have to go into the computer and rewrite the software
1helpful
1answer

Disable anti-theft system 98 ford explorer

Hello,

The key has the chip for the anti-theft--may not be the anti-theft.
TDC/Firing Order/fuel/spark/compression/timing chain alignment (dots)
TPS (Throttle position sensor) - Bypass by holding gas pedal down and starting.

Hope this helps--
0helpful
1answer

2003 ford mustang gt anti theft light flashing engine will turn over but will not start

From my experience...
A non PATS coded key SHOULD not turn the STARTER...!

If ANTI-THEFT were invoked... you can attain a not start condition which the Owners Manual says must be cleared by the dealer.

A working PATS key should disable the anti theft... by turning the ignition on... ELSE try your other key.

The SecuriLock [PATS]
passive anti-theft system is not compatible with
non-Ford aftermarket remote start systems. Use of these systems may
result in vehicle starting problems and a loss of security protection.

Owners Guide (post-2002-fmt)
USA English (fus)

OWNERS MANUAL
Ford 2003 Mustang Owner Manual

SHOP MANUAL
Ford 2003 Mustang Workshop Manual
0helpful
1answer

Disable anti theft on ford taurus

You can't , your best bet is take your vehicle to the ford dealer an have it checked out . The ford PATS - passive anti-theft system is intertwined in all the computer systems on the vehicle . I don't even think you can go into the system with the ford diagnostic tool an disable it . There is no where you could just disconnect it , it's software programmed into the modules (computers) on the vehicle .
0helpful
2answers

Lincoln tow car 2001 passive anti tip DTC 1260 I replaced pcm.trancevier.instrument cluster.2new ignition key but no communication this module what possible problem this?

No where in the DTC - description does it say anything about replacing any modules . An does not have anything to do with a communication problem ! You need a professional grade scan tool to communicate with the PATS system ! An if you don't know these thing's you better take it to pro !!!!!!!
P1260 - Theft Detected - Vehicle Immobilized Indicates that the passive anti-theft system (PATS) has determined a theft condition existed and the engine is disabled. This DTC is a good indicator to check the PATS for DTCs.
  • Previous theft condition
  • Anti-Theft System failure
Theft indicator flashing rapidly or on solid when ignition switch is in the ON position. Check anti-theft system for DTCs. Typical vehicle symptoms are: Start/Stall or Crank/No Start. NOTE: No crank symptom only on vehicles equipped with PATS starter disable feature
0helpful
1answer

Could anti-theft system d mustang cause car to shut off while driving?

Hi, im a retired ford tech, with alot of experience on ford anti theft . Now if you are asking about a built in oem factory anti theft, your not going to be able to bypass it. Now to answer your question, I would say your factory anti theft IS NOT causing your issue. It will make it unable to start,it doesnt kill anything else.
0helpful
1answer

What does code p1260 means?

P1260 code:
Vehicle Immobilized Indicates that the Passive Anti-Theft system (PATS) has determined a theft condition existed and the engine is disabled. This Detected Trouble Code (DTC) is a good indicator to check the PATS for DTCs. Previous theft condition Anti-Theft System failure Theft indicator flashing rapidly or on solid when ignition switch is in the ON position. Check anti-theft system for DTCs.

Read more: http://engine-codes.com/p1260_ford.html#ixzz3AD8HNiKO

Ford OEM Motorcraft parts and vanity license plates
Not finding what you are looking for?

1,590 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...