My brake lights wont work or my blinkers, i need a diagram of the wiring
Stupid question but have you checked your fuses yet? Second, it could be your brake light switch behind the brake pedal. Next, try your hazards....does the rear blink? When you use your turn signal lever, do the front lights blink properly or at all?
SOURCE: i need a fuse diagram for 2001 impala
go to autozone and get a fuse tester and you might have a short in a wire
SOURCE: need help with the wiring diagram for my 92 Dakota, has not brake lights or blinkers
www.wiring-diagram.com
You can get any wiring diagram for any vehicle. It will cost about $12 and it's well worth it. It will give you the complete diagram bumper to bumper.
SOURCE: brake wiring diagram chevy lumina
why not just replace the turn signal switch must faster and safer . buy one from your local parts house then you can see its not that easy to install but you can do it with a little help
SOURCE: I am attaching tow lights to my Chevy Colorado,
You need an adapter to make them work properly...
Check this it out it will help alot...
http://www.coloradofans.com/forums/viewtopic.php?f=1&p=815675
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
SOURCE: need a wiring diagram for a chevy s10. brake
your power starts at the brake light fuse,check with a test light,then proceed to stop light switch on brake pedal under dash,one wire will be hot when when you check it with your test light, the other won't be until you press down the brake pedal then the power flows through to the second wire,if no power to second wire replace switch,if you have power remove tail light bulbs and check for power in side socket.
286 views
Usually answered in minutes!
×