Its coated in the trunk lid
SOURCE: 2002 license plate bulbs
its real simple look at the license plates then look up you will see 2 screw per lamp / unscrew them and slide remove its a 194 bulb so get some ready then replace and put back / Please rate my response thank you very much
SOURCE: bulb burnt out on license plate
you need the remove the lighting fixture first to access the bulbs.
SOURCE: 2000 Buick Lesabre custom liscense plate bulb
kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together
SOURCE: license plate and trunk lights not working
Simple fix! OPen your trunk and look at the right side trunk hinge for a bundle of wires. Honda made the license plate wire a little too short and when you open your trunk it pulls on the wire a little until it disconnects. I'm pretty sure it a red/yellow wire but trace it to be sure. All I did was add a little length of wire between the two and haven't had a problem in over a year. BTW, the wires are wrapped in a ton of black tape. Hope this helps.
316 views
Usually answered in minutes!
×