My 92 accord starts fine and idles great .but when i apply the gas peddle sharply or hold it to the floor. it stalls and the rpm gauge jump around it will go to 1 . on the road if i get it up to around 30 to 50 . mph ... the rpm gauge will go crazy up and down and will continue in that manner what could be making it run this way what can i do to fix this ?
Throttle positions sensor, idle air control valve or could be timing belt. not sure if that engine has the interference engine, but you might want to check the timing. easiest fixes are the sensors stated above that are located on your throttle body
Replace the distributor unit. its a common failure on older civics and accords.
Roger
Check the air inlet tube for cracks. Duct tape will work in a pinch.
SOURCE: Civic '92 engine normal starts then stalls after 2 mins
Ihave the same experience try to remove the idle jet located next to the starting jet. But be careful in removing it as it will break easily ( you will need a flat screwdiver to do it ) clean it with a wire that closest size of the jet. change your fuel filter ang drain all the fuel inside before putting it back. make sure to put some air pressure on each holes on the carb so it flush all unwanted particles inside and pls dont use silicone in sealing the rubbers inside.
SOURCE: 1995 Honda Accord stalls when you do not press the gas petal
Sound like a clogged or defective IAC. (Idle Air Control) It's usually part of the throttle body assembly. It can be removed and the passage ways cleaned out with old fashion carburetor spray cleaner. If that doesn't help you may try replacing the IAC to see if that solves the problem.
SOURCE: I have a 1995 honda
I have a chevy truck and my throttle position sensor had a short in the wiring harness one of the wires was touching the valve gasket cover and rubbed so much it cut the wire in half so i got a wire but splice and connected the wire back together after i had already bought a new sensor hope this helps also check my post i wrote a little tip about my problem my engine was idling at like 3500 rpm and i had an engine code p0121 &p0123 is your engine light on
204 views
Usually answered in minutes!
×