'99,2500, 6.0, GMC Sierra,4x4
where do we find the correct diagram?
(each year is different)
replaced part of brake line where it had rusted; ( now won't bleed on
passenger side ) we're told it maybe hooked up backwards-
would Chilton Manuel show us? or do we have to look at another truck of that year? Thank you-
If you only patched I doubt if you could have reversed the system. you could have a clogged line wheel cylinder or caliper.
SOURCE: replacing front rotor
after removing the wheel &caliper depending on rust build up you may need to hit the rotor between the wheel studs this may take some time after removal check for rust build up on hub remove rust with hammer, sanding&scraping put some anti seize lube around hub making sure no rust is caught in between depending if you are replacing the pads you have to push the caliper piston back with a large pair of chanel lock pliers or suitable tool,then you can reassemble.thanx from schleck
SOURCE: wire schematics for a 1995 chevy cheyenne 2500
You only have a few choices. Buy a repair manual at a parts store. Go online and google wiring for your truck and you might find it posted for free. Go to Alldata .com and pay for the info you need or ask nicely at a repair shop or dealer that can print off the required info.
SOURCE: where is the 4x4 encoder motor sensor located on my 03 sierra
the encoder motor sensor is inside the encoder motor. the encoder is located at the transfer case. Remove the encoder and by part number 88962315 this is the sensor. you will have to retime the motor after
hope this helps
SOURCE: I'm looking for a good electrical schematic for
Try this research site. Site requires a log-on. Just get a library card from your local library and enter the code. Great info site as well as wiring schematics!
http://arrc.epnet.com/autoasp/index.asp?sid=171714302&uid=s9210915.main.autorefctr
SOURCE: 1999 GMC Sierra 2500 4x4 airbag light remains on
check to see if the horn still works if not replace clock spring
346 views
Usually answered in minutes!
×