Power windows and door locks not working
If no door or window switches work in entire car start by checking FUSES , then by spraying compressed air into the switches on the drivers door panel whilst moving switches back and forth. then spray some WD40 or electronic componet cleaner into edges of switches whist moving switches hoping they come back to life. then pulling open drivers door rubber harness cover where it enters car. look for wires in the loom that are cracked and broken. this is likely.as wires bend each time door is opened. then remove drivers door panel and test then remove loom connector from door frame and use OHM /volt meter to find broken wires or switches in drivers door problems in drivers door. check for voltage at window motor first. . buy whole new door panel with wiring harness and switches at Pick n pull. if that does not work ..buy a haynes manual and look at wiring schematics. NEVER GIVE UP. NEVER BUY NEW PARTS.
SOURCE: driver side power window stopped working
The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps
SOURCE: I HAVE A 2005 CHRYSLER SEBRING AND DOME LIGHT,RADIO ALL POWER LOCKS HAVE QUIT WORKING
me too! - looking at fuse #5 red 10 Amp one but has black thing on it.
Can't get if off..
Have read the manual is wrong and to use panel on side of fuse box for fuse locations...
SOURCE: How do I replace the window motor in my car?
take the door panel off...should be 3 bolts holding motor inplace and wiring to unplug...make sure the window is up when attempting ...its not as difficult as it seems thanks and have a good day
SOURCE: power door locks on 2005 chrysler town and
There is an ecu flash for this repair. You may get the locks to start working again with a battery disconnect.
SOURCE: My Driver side window in
Andrew, it may have lost power to it due to a bad wire or a loose wire. Also, the window track bar may be broke or it may br off track. You have to take the panel off of the door to find out. Since your other three work, it is not a fuse. I am not familiar with the new panels. The old ones have screws on the outside of the panel and one for the door handle. It has to come off to fix the issue. Once you remove the panel, remove the plastic sheet and foam in the inside of the door. You will be able to look at the window after that. Test your wires for current and make sure none have came loose. Make sure the window is not off track and the window bar is at the bottom of the window. It goes down with the window and pushes it back up. Get a voltage reader and test the wires for power. If they have power, it is not the wires. 4 thumbs up is appreciated if you appreciate the reply. Andrew, don't hesitate to ask me a question. I am here to help you.
324 views
Usually answered in minutes!
×