How do I change th0e heater blower fan on a 2000 chev tracker
SOURCE: tickin 2000 chev tracker
if its a ticking when you start from cold and goes away soon after start as the engine warms up it is most likely a crack in your exhaust manifold ( you may call it a header in the us) as it is getting the hot exhaust straight from the cylinder it heats up very quickly and closes the crack stopping the ticking. you should be able to get a nechanic to run a weld along the crack easily enough depending on where it is.
SOURCE: HEATER FAN ON BMW 323I HAS STOPPED WORKING 2000
FOUND SOLUTION ON WEBSITE INDICATING ELECTRICAL PART REQUIRED.
SOURCE: I have a 2000 sportage. The heater fan does not
It may be the blower motor, or it may be the blower resistor. Check for power at the blower motor. If power present with system on and blower has good ground, motor bad. If no power check blower resistor in air box prior to blower motor. If power on input side but nothing coming out to blower change resistor.
SOURCE: How do you replace the crankshaft sensor on a 2000
If you have doubts about doing this repair I suggest you let and Certified Mechanic (ASE) do the repairs its not and easy task
REMOVAL PROCEDURE
INSTALLATION PROCEDURE
NOTE: Do not pinch or damage the
CKP sensor wire harness between the engine block and transmission during the
transmission installation. Observe that the CKP sensor wire harness remains
properly located in the channel provided at the rear of the engine block during
the installation.
Good luck
199 views
Usually answered in minutes!
×