Free ford troubleshooting

SOURCE: ford starter won't disengage even after the ignition is switched

sounds like to me that the ignition is bad and sticking on the start positon

SOURCE: 94 ford escort fuel pump runs continuously... key

Change the fuel pump relay.

SOURCE: 96 ford windstar ignition probs

the ignition switch is the electrical part behind the lock cylinder where the key goes in.

Ignition Switch Lock Cylinder
Lock Cylinder Functional
Removal

1. The following procedure applies to vehicles that have a functional ignition switch lock cylinder (11582) and keys. If the key numbers are known, the correct key can be made. Disconnect the battery ground cable (14301). For additional information, refer to Section 14-01 .
   

1. Turn the ignition switch lock cylinder to the RUN position.
   

1. Place a 3.17-mm (1/8-inch) diameter wire pin or small drift punch in the hole in the steering column shroud under the ignition switch lock cylinder. Depress the retaining pin while pulling out on the ignition switch lock cylinder to remove it from the housing of the steering column.
   

1. Install the ignition switch lock cylinder by turning it to the RUN position and depressing the retaining pin. Insert the ignition switch lock cylinder into the steering column housing. Make sure the ignition switch lock cylinder is fully seated and aligned in the interlocking washer before turning the key to the OFF position. This will permit the retaining pin of the ignition switch lock cylinder to extend into the hole of the steering column.
   

1. Using the key, rotate the ignition switch lock cylinder to make sure of correct mechanical operation in all positions.
   

1. Connect the battery ground cable.
   

1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
   

1. Remove the upper steering column shroud (3530) by removing the four or five self-tapping screws. Remove key release lever (3F527) (if equipped).
   

1. Remove lower steering column shroud.
   

1. Disconnect the ignition switch electrical connector.
   

1. Rotate ignition switch lock cylinder (11582) to the RUN position.
   

1. Remove the two screws retaining ignition switch (11572).
   

1. Disengage the ignition switch from the actuator.
   

1. Adjust the ignition switch by sliding the carrier to the ignition switch RUN position.
   

1. Check to make sure that the ignition switch lock cylinder is in the RUN position. The RUN position is achieved by rotating the ignition switch lock cylinder approximately 90 degrees from the LOCK position.
   

1. Install the ignition switch into the actuator. It may be necessary to move the ignition switch slightly back and forth to align the ignition switch mounting holes with the lock cylinder housing threaded holes.
   

1. Install retaining screws. Tighten to 5.6-7.9 Nm (50-69 lb-in).
   

1. Connect electrical connector to ignition switch.
   

1. Connect battery ground cable. Refer to Section 14-01 .
   

1. Check ignition switch for proper function, including START and ACC positions. Also, make certain that the column is in the LOCK position.
   

1. Install upper steering column shroud.
   

1. Install the lower steering column shroud and key release lever (if equipped).
   

SOURCE: key didn't want to go into ignition of 2003 ford escape

need a new ignition switch

SOURCE: Horns blares continuously when key is removed from ignition!

Locate the fuse for the horn and see if nothing else is ran off the same fuse then remove the fuse.