Panic alarm keeps going off

panic alarm or content theft system alarm . The vehicle think's the vehicle is being broken into ? Do the light's flash as well ?

central timer module" - Dodge Dakota Forum

www.dodgedakota.net/boards/gen/21983.html

Jan 2, 2009 - 21 posts - ‎18 authors
I have a Dak 2000 3.9 Ltr V6, Single Cab, Bare Bones. ... Panic Mode .... ooops....i mean the remote entry and alarm system does NOT work ... i have a 2002 dakata where can i buy a ctm looked all over nobody sell them can thay be rebuilt ... I was out the door $550.00, and they washed the truck also.

Truck wont work/Key Fob won't work/wont start/wont do anything ...

www.ramforumz.com > ... > Electrical

Apr 10, 2010 - 10 posts
Truck wont work/Key Fob won't work/wont start/wont do anything! ... Maintenance & Repair > 3RD Generation Dodge Ram - 2002 to 2008 Dodge Ram Trucks > Electrical... Soon as I manually unlock the door, and open it.... the factory panic alarm starts going off. .... Vehicle: 2004 Dakota Club Cab 4X4.

alarm going off when opening the door.. embarrassing and annoying ...

www.cumminsforum.com > ... > 3rd Gen. Non-Powertrain

Jan 12, 2012 - 11 posts - ‎9 authors
how do I stop my trucks alarm from going off when I open the door? it did it ... to thetruck and opened driver door (it was unlocked) and the alarm started going off. ... I do not have a remote unlocking device (or it doesnt work) so I do all .... alarm will go off then I have to use the FOB panic button to shut it off.

Keyless entry/panic button/alarm - Dakota Durango Forum

www.dakota-durango.com > ... > Gen III Dakotas

Your door locks are controlled by a control module . GEM - generic electronic module . Watch this video ! Door Locks Go Crazy 1 You possibly have a bad door switch .

Did you test for a failed battery

At night on some vehicles Emission Monitors
run & you could have low module voltage

Try unlocking the car with the key, not the remote.

disconnect the batterie for an hour and see if it resets itself

change battery in your key fob

if its the remote then it needs to be swapped out. it could be the alarm module if the remote is not the thing that malfunctioning. i would get the alarm reprogrammed by the dealer and the whole module and go from there.
so in order, 1. reprogram whole system 2.replace remote 3.replace module

You have a bad or sticking door adjar switch. The switch is located in the latch assembley inside the door. Most of the time you can take some WD40 and spray it into the latch,put a good amount on it,then open and close the door several times.

Being that this is a 2008 pt cruiser, I would take it back to the dealership and let them look the car over!! Should be covered under warranty!!