Changing fixture
SOURCE: replace driver side rear light
Hi,
Most are held in from inside the vehicle with clips or very few screws.
You would need to remove any carpet trim first - and be careful of sharp edges.
the "press stud" type fixings can be removed easily without damage by sliding a fork or two blunt knives either side to lever them out.
SOURCE: How do I change the bulb(s) for the lights in the
open up trunk there is a place where you can loosen up the light panel take that off and you can get to the lights
SOURCE: how do you change the turn signal light, driver
Try it checking this ZJ-Secc-23-Body-Components
Hope help (remember rated this).
SOURCE: 1997 chevrolet lumina
If your talking about the headlamp, open your hood, look right behind the headlamp and you will see either two or three black funny looking nuts (I think they call them "wing nuts") turn them off while holding on the headlamp, then pull headlamp out slowly, unplug the headlight bulb, grab the back of the headlight bulb, turn and pull it out. (Put a plastic bag, like a sandwich bag over your hand). DO NOT touch the headlight bulb with your hands or you will burn out the bulb. These are very sensitive bulbs and DO NOT like the oils from your skin. Set it down somewhere very safe so it will not roll or touch anything greasy or oily. Next, unplug the parking light, turn and pull out. Replacement is reversal. Hope this helped!
SOURCE: Driver side dome light fixture popped free into
Did you ever find out how to remove the dome light counsel, I have the same problem.
32 views
Usually answered in minutes!
×