Question about 2001 Nissan Almera Tino

1 Answer

No indication low oil levelproblems nissan almera

Why do i not get low oil warning

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 1,209 Answers

Could be a bad oil level sensor or possibly a wire problem going to the oil level sensor.

Posted on Aug 30, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
jameel infot
  • 15 Answers

SOURCE: Engine warning light on Nissan Almera 03

its very simple. You can see a black hose from the engine which connects the metal pipe. just remove it and you can see three gold color pin from the metal pipe. scratch that pins using a salt paper and fix it. Now check whether you get started or not. Thanks.

Posted on Jul 03, 2009

  • 1 Answer

SOURCE: My car won't start. Nissan

MY 1998 NISSAN QUEST WONT START, TURN OVER NOTHING,  MY LIGHTS AND RAIDO WORK DONT THINK ITS THE BATTERY.  WHAT ELSE COULD IT BE?

Posted on Jul 13, 2009

  • 50 Answers

SOURCE: How do you reset the water warning light on a

fill with appropriate amount of coolant

Posted on Oct 06, 2009

  • 1 Answer

SOURCE: nissan almera problems side light

heater blowing cold air only

Posted on Jan 04, 2010

emissionwiz
  • 85161 Answers

SOURCE: nissan almera ecu light

disconnect the battery negative cable for 5 minutes

Posted on Mar 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Resetting after installing a radiator on nissan almera


Not sure on the Almera, but some vehicles need the light to be re-set with a scanner, it has stored the radiator fault in it's memory, trip to a garage I'm afraid.

Jan 21, 2014 | Cars & Trucks

1 Answer

My nissan Almera S reg has no side lights or dash lights.All fuses seem ok.


This solution will be of great help to you,even in the case of future or other dashboard problems;
Instrument cluster consists of electronic analog gauges, various warning lights, and optional tachometer. Vehicles equipped with tachometer have an electronic vacuum fluorescent transmission range indicator (PRND3L),odometer and trip odometer display. Vehicles without tachometer are equipped with a cable-operated transmission range indicator.
Instrument cluster is equipped with the following warning lights:
Battery voltage.
Cruise (speed control).
Door ajar.
Fasten seat belt.
Lift gate ajar.
Low fuel level.
Low windshield and washer level.
Traction Control.
The Body Control Module (BCM), which receives input from various sensors, sends display information to instrument cluster and operates gauges. Instrument cluster incorporates a self-test diagnostic feature to identify electronic problems. BCM, Powertrain Control Module (PCM), and Transmission Control Module (TCM) are continuously monitored by the diagnostic system.

SELF-DIAGNOSTICS
With ignition off, press and hold TRIP and RESET buttons while turning ignition switch to ON position. Continue to hold TRIP and RESET buttons until odometer window displays CODE (approximately 5 seconds). If problem exists, system will display diagnostic trouble codes. See DIAGNOSTIC CODE CHART table. If no problem exists, Code 999 (end test) will be displayed.
DIAGNOSTIC CODE CHART
CodeDescription
110.......Cluster Memory Fault
111.......Cluster Calibration Fault
905.......No CCD Bus Message From TCM
921.......Odometer Fault From BCM
940.......No CCD Bus Message From PCM

After diagnostic code display ends, instrument cluster will go into each of the following tests in order:
Dim test.
Calibration test.
Odometer segment test.
Electronic Transmission Range indicator segment test.
Dim Test
CHEC-0 will be displayed in odometer window. Instrument cluster will dim Vacuum Florescent (VF) display. If VF displays do not dim, a problem in instrument cluster exists. See BODY CONTROL COMPUTER TESTS in BODY CONTROL COMPUTER article.
Calibration Test
CHEC-1 will be displayed in odometer window. Each of instrument cluster gauges will move sequentially through each calibration point. See GAUGE CALIBRATIONS table. If gauge needle is not calibrated properly, a problem in instrument cluster exists.

Odometer Segment Test
CHEC-2 will be displayed in odometer window. Each segment of odometer will light sequentially. If any segment does not light, replace instrument cluster.
Electronic Transmission Range Indicator Segment Test
CHEC-3 will be displayed in odometer window. Each segment of electronic transmission range indicator will light sequentially. If any segment does not light, replace instrument cluster.

Sep 10, 2012 | 2005 Nissan Almera 1.5

1 Answer

Failed emissions test nissan tino


Mine just failed emissions test garage said its burning oil what is the soulution

Apr 19, 2012 | 2004 Nissan Nissan almera tino

1 Answer

Oil light flashes on and off


Your description sounds serious. The next step is to check the oil level, then check the oil pressure with an external gauge. If the pressure is low, the news is not good and you need to disassemble the engine until you find the issue. The clanking does description does not sound good.

Feb 05, 2012 | 2005 Nissan Almera 1.8

1 Answer

Does the 1992 dodge dakota automatic trans have a fuse to overdrive button


The fuse number is

#16 - 5 Amp (Tan)

Gauges & Indicator Lights: Low Oil Light, Low Washer Light, Service Reminder Light, Transmission Oil Light, Brake Warning Light, Anti-Lock Brake Warning Light, Fuel Pacer Light, 4WD Indicator Light, Malfunction Indicator Light, Warning Buzzer, Overdrive Switch (1992-93); Transmission Oil Temperature Lamp, 4WD Lamp, Overdrive Module Seat Belt Warning Buzzer
(1994-95).

Jan 25, 2010 | 1992 Dodge Dakota

2 Answers

Nissan Almera Air Con Advice


It may be low on refrigerant if the pressures are to low, the compressor will not engage.

Jul 31, 2009 | 2000 Nissan Altima

1 Answer

Engine warning light on Nissan Almera 03


its very simple. You can see a black hose from the engine which connects the metal pipe. just remove it and you can see three gold color pin from the metal pipe. scratch that pins using a salt paper and fix it. Now check whether you get started or not. Thanks.

Jul 03, 2009 | 2003 Nissan Altima

2 Answers

Nissan Almera


The malfunction indicator is not lighting up initially.

Jun 07, 2008 | 1996 Nissan Altima

Not finding what you are looking for?
2001 Nissan Almera Tino Logo

Related Topics:

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...