Car was stalling and when at a red light acted like it wanted to stall. Changed crank shaft sensor now when I start the car then drive off the car like jolts and hesitates I let go of the brake then press gas and its fine after that but the check engine light is back on and code coming up po715. Someone please help its stopping me from it getting inspected!
SOURCE: 2002 sequioa sudden stall
Often when the battery is disconnected or replaced the computer will lose it's learned idle settings. You could try letting the engine idle in park until the engine temperature comes up to normal and leave it like that for a few minutes, then put the Air con on and let it idle again for a few minutes, then switch the air con off and put it into drive. If it does not stall, let it idle in drive for 2 minutes or so, and then do the same with the Air con on. This should relearn the base idle settings and stop it from stalling on you. Before you carry out this procedure you should make sure that when you replaced the battery you didn't remove any other plugs or knocked anything that may be causing the fault. If you try this procedure and it still stall when you select drive, you will need to get a Mechanic to check the vehicle over.
Hope this helps,
Mark.
SOURCE: 95 Ciera Hesitates & stalls when warm
Change the IAC the idle air control. You may be able to clean it and put it back on.
SOURCE: 1999 Jeep Grand Cherokee Laredo won't run
if ur jeep has central lockin lock it and then unlock it ..........she might b sucking air inn
SOURCE: car stalling in while in drive, also surging when brake applied in drive
you need a new mechanic. your mechanic should be able to troubleshoot your vehicle and not just replace parts. did he give you a redit for not fixing the problem
SOURCE: engine light is on ,code P0171, hesitates when start driving
you will need a code reader to turn light off
113 views
Usually answered in minutes!
×