Fuse keeps blowing an ecu wire is dried an needs replaced
SOURCE: ecu/ecm relay
It is located behind your radio/heater control bezel. Labor time to replace 1.4 hrs
SOURCE: How to replace headlight bulb hyundai elantra 2004
yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx
SOURCE: blown ecu fuse
ECU= Electronic Control unit. This is what controls all the engine electronics. All the sensors on the engine and other things are routed through the part. What it does is tells the engine how to run. Each sensor plays a specific role. The ECU reads how much are the engine is getting, tells the engine how much gas it needs, etc. Try digging around a salvage and finding a new ECU. Swap it out, and if it is still blowing the ECU fuse then you need to start looking for shorts.
SOURCE: 1999 Hyundai elantra died while driving found ecu
Check your o2 sensor harness. The harness if not properly secured will rub on the axle to a point where it rubs through the insulation of the wire & shorts on the axle causing the ECU fuse (20A) to blow. Repair the harness & replace the fuse & bada bing! You should be in business! Hope that works. IF NOT follow this K.I.S.S.
Keep It Super Simple! It never fails!
SOURCE: I have a 2000 Hyundai Accent that keeps blowing
The ECM1 fuse blowing usually indicates that the fuel pump wires shorted inside the tank. If you drop the tank and remove the module, you will probably find the insulation burned off the gray pump wire.
168 views
Usually answered in minutes!
×