New brakes, full master cylinder new right rear speed sensor. cruise control doesn't work. I erase the code but it comes right back.
SOURCE: no speedometer,abs or cruise control
yes that could be related..unless you did'nt hook back up that sensor or sensors..
SOURCE: 2002 Dodge Dakota
well because the abs light indicates a problem with your anti-lock braking system you need to find out why it is on.... keep in mind one quick way you would disengage your cruise is with the brake pedal.
under the hood is a fuse panel (often located near the battery) ... see if there is a relay in the for your cruise... replace that.
Robert
SOURCE: P0573 code on a 2005 Dodge ram hemi, replace speed
P0573 is for your brake switch stuck. It means you either have a bad brake switch, or a bad wire.
SOURCE: Need Help. My 2005
The ABS and BRAKE warning lights are on in the cluster because there is an active fault in the ABS module. The speed sensors that you have replaced are not direct inputs to the instrument cluster. Your truck should have one or possibly two front wheel speed sensors and one speed sensor in the rear diff. These are all direct inputs to the ABS module which are then calculated and sent out on the "bus" communication wire which is read by the cluster. It would be much easier to diagnose this problem by knowing what the active codes are in the ABS module.
SOURCE: 2004 dodge ram 5.7 liter
Disconnect the abs control module connector (located on the left fender near firewall) and see if there is any water in the connector. Also, the system also uses the left front speed sensor for the abs and speed inputs. Check the wiring to it and alos for looseness in the hub.
820 views
Usually answered in minutes!
×