2004 Chevy Silverado. all for brake calipers are sticking front to have been replace + lines the ABS light is not on

Lots of video help in the link. Some vehicles have a shim kit which you have to buy as an extra part kit. Mine does.

https://www.google.com/search?q=2001+Chevy+Silverado+brake+caliper+not+releasing

..

The front disc rotor for the right side is warped, and the caliper may be sticking.

the abs valve assembly is under the drivers seat mounted on the frame if a gear went bad it will keep trying to move the valves it has a electrical plug on it and you will see all the brake lines go in and out of it

Your brake calipers may be sticking to the brake rotor causing your abs sensor to come on. If it sticks to the rotor for an extended period of time, it could cause the caliper to actually weld itself to the rotor. I am assuming it is doing this in the front. If this is the case, you will need to replace both brake calipers, both rotors and a new set of brake pads. It is more economical to put the better parts back on it, if you can afford it.

It sounds like a faulty sensor wire on one of the calipers, I'd check the front first because they move around more than the rear. If the brakes have been replaced, sometimes the sensor wires don't get instaaled right and they either don't make contact or they get broken, difficult to put in unless you have experince with the new brake systems.

you have to replace caliper if its sticking could damage ur rotor as well as strain ur engine because of the locking up

Your brake calipers need to be replaced.

remove brake caliper and rotor 1 screw holding sensor will need to clear code and test drive

Hello,
I hope this helps.







Thank You,
Roy