Running lights not working
SOURCE: Legacy wagon tail light replacement
The one thing youll find with subaru's is that they like to put nuts in funny places that are hard to access. There are either 3 or 4 nuts holding the tail-light assembly in place, which means youll need to take out most of the inner panels to access the others. You should not need a sealant unless the rubber seal is done for or there is water inside the car. Hope this helps
SOURCE: will 1999 subaru engine fit in 1997 subaru legacy?
Yes as long as the Motors are the same. You might need to have the computer out of doner car. Doors are suppose to fit 96 to 99.
SOURCE: 92 Subaru Legacy Power Windows Don't Work
I have a 92 that did the same. After checking fuses and the relay(located under drivers seat) I discovered that the power windows control module on drivers door was bad. Went to a salvage and bought a used for $40, pulled the door panel, unscrewed and unplugged the old one, put in the used one and everything worked fine. About a week later, the passenger side motor went out and replaced that with a used power window motor. All windows now work fine.
SOURCE: 2001 Subaru Outback tail lights don't work
do you have a trailer hitch? if yes disconnect convertor box the light behind the dash should not be related bulb just out, also make sure bulbs you've changed are correct
264 views
Usually answered in minutes!
×