1995 Lexus ES 300 Logo

Related Topics:

D
Derrek Schmitz Posted on Aug 25, 2014

Where is the turn signal flasher relay 1995 Lexus es300

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jun 26, 2008

SOURCE: no flashers or turn signals

Try the fuse/breaker panel under hood, drivers side.

Ad

griffbob

  • 1 Answer
  • Posted on Dec 04, 2008

SOURCE: Where do I install the electronic flasher relay for the turn signals?

If the turn lights come on and don't flash, like mine did, I found the flasher behind the ashtray.If you can't reach it,there are only 4 screws holding the bracket (1/4 in.nut driver) that holds the ashtray.

Anonymous

  • 96 Answers
  • Posted on Apr 30, 2009

SOURCE: 1995 Jeep Grand Cherokee Limited - flasher relay location

More than likely you have a bad ground. Under the rear of the vehicle, behind the rear bumper there will be a few wires running to a bolt in the frame (left side i think) Check that no wires are loose or boken. Also if you have a trailer wiring harness, check to see if it has not been damaged. Let me know if this helps :)

Anonymous

  • 672 Answers
  • Posted on Aug 31, 2009

SOURCE: where is the thermostst on 1995 lexus es300

Its located on the RH side of the engine and above the transmission. The lower radiator hose(RH side) runs to an inlet pipe, at the end of the pipe there is the thermostat housing. The thermostat is located in the thermostat housing. Hopefully this helps!!

Anonymous

  • 5081 Answers
  • Posted on Nov 16, 2009

SOURCE: need to replace thermostat but not sure where it

Follow the lower hose up to the water pump where there is a housing for the thermostat. To remove this you will first, want to take the front right tire off then the dust guard for it; the thermostat housing should now be viseable. Then you will want to take the plastic windshield washer, and engine coolant reserviors off to make the job easier. Next take the bottom rad. hose off the water pump(where it goes to, from the radiator). then struggle for awhile with taking the three nuts that hold the thermostat housing together (a wobbler bit on a socket wrench can make this job easier). Once these are off you can unplug electric plug on top of the housing, pull that part of the housing off and there the thermostat sits in all of its evasive gloriousness waitng for you .

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the relay for the turn signal/ flashers on a 1995 Monte csrlo

The turn signal/hazard flasher relay on a 1995 Monte Carlo is located in the convenience center, which is located behind the dash on the driver's side. To access the convenience center, you will need to remove the lower dash panel on the driver's side. Once you have removed the panel, you should be able to see the convenience center and the flasher relay.
The flasher relay is usually a small, square-shaped component with two or three prongs that plug into the convenience center. If you are unsure which relay is the turn signal/hazard flasher relay, you can consult your vehicle's owner's manual or contact a mechanic or dealership for assistance.
0helpful
1answer

How do I fix code 13 engine speed sensor Above 1000 rpm

Clearing the codes is simple that is done by removing the fuse of the EFI from junction box 2 for 10 seconds. Make sure to remove the jumper wire and switch the key off before clearing the codes.

Here are some common Lexus vehicles 1990-1995 codes:

Code 12 and Code 13 Rpm signal circuit fault
Code 14 Igniter signal circuit fault
Code 16 ECT control signal fault
Code 21 and Code 28 Main oxygen sensor fault (for ES300; SC300 & GS300 models)
Code 22 Coolant temperature circuit fault
Code 24 Intake temperature sensor circuit fault
Code 25 and Code 26 Air fuel ratio fault (for ES300 & SC300 models)
Code 27 Sub-oxygen sensor circuit fault (for ES300 CA & GS300 models)
Code 31 Low airflow meter voltage (for ES300 and GS300 models)
Code 32 High airflow meter voltage (for ES300 model)
Code 35 Barometric pressure sensor circuit fault (for GS300 & SC300 models)
Code 41 and Code 47 Throttle position sensor circuit fault
Code 42 Vehicle speed sensor circuit fault
Code 43 Starter signal
Code 51 Switch condition signal fault (for ES300; GS300 & SC300 models)
Code 52 Code 52 and Code 55 Knock sensor circuit fault
Code 71 EGR system circuit fault (for ES300; GS300 & SC300 models)
Code 78 Fuel pump control circuit fault (for GS300 & SC300 models)
0helpful
1answer

Turn signal flasher location

change your flasher relay it will have failed. just google that part.
2helpful
1answer

1992 lexus es300 flasher relay location

It is located beside the emergency brake pedal and is the approx. 3/4" square fuse. turn on your signal light and hold on to it you will feel it click.(Addendum) The replacement may only have 3 working prongs; the 4th prong on mine had a soldered connector but wasn't connect to anything. I also had to remove the left kick panel to get to it; a simple operation.
0helpful
1answer

1995 lexus es300 fuse box diagram

On this website, you find fuse box diagram and description for Lexus ES300 (1994 - 1995)

Lexus ES300 1994 1995 fuse box diagram Auto Genius
0helpful
1answer

1994 lexus es 300 fuse box diagram

On this website, you find fuse box diagram and description Lexus ES300 (1994 - 1995)

Lexus ES300 1994 1995 fuse box diagram Auto Genius
0helpful
2answers

Where can I go On-Line to find the Signal Lights and Hazard Flasher relay switch for 1995 Lexus SC400 or what is the part #? The Fuses and Tail lights are all Ok., but the Signal and Hazard lights do not...

your local auto parts store can give you your specific information, as can the parts desk person at your local dealership or possibly even an aftermarket repair shop by using an electronic component locator manual. your local auto parts store will probably be the most willing and friendly.
0helpful
1answer

Left turn signal

Hi my name is Tom and I am here to help you.

Turn signals flash rapidly if your say left signal circuit is not getting enough voltage. Check and clean all the contacts both front and rear systems. Make sure that the sockets the bulbs go into are clean. Check after you clean and the flasher should slow down and you lights should be brighter. Simply put the 12 volt lights are only getting a lot less than 12 volts.

If I can be of further assistance please call or mail me

Tom(karatebb2)
Not finding what you are looking for?

592 views

Ask a Question

Usually answered in minutes!

Top Lexus Experts

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...