1998 Mercedes-Benz C-Class Logo
A
Anonymous Posted on Aug 23, 2014

How to stop beeping

Car parked or stopped no beeping, car moving beeping continuously until stopping again. Brake light on as well as as rand check engine light

1 Answer

DRB2009

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Governor:

An expert whose answer got voted for 20 times.

  • Mercedes-Benz Expert 107 Answers
  • Posted on Sep 09, 2014
DRB2009
Mercedes-Benz Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Governor:

An expert whose answer got voted for 20 times.

Joined: Jun 06, 2009
Answers
107
Questions
0
Helped
53628
Points
337

Sound sleek you have two problems. Check your brake fluid level immediately for the beeping and brake light on!
The check engine light is a completely different story.
I recommend you take it to a shop.

5 Related Answers

Anonymous

  • 61 Answers
  • Posted on Aug 10, 2008

SOURCE: 2002 clk 430. my car

its sounds like the classic case of the stop lamp switch going bad,you step on the pedal,esp sees a difference in the pressures at the booster,but doesnt actually see the pedal moving because the switch has gone bad,also causing the vehicle to not come out of park because this vehicle is designed to not come out of park unless the key is in position 2 and the brake pedal is depressed.if you really need to get the car out of park to get somewhere,on these models i believe there is a flap of plastic just below the d on the shifter panel that has a spring on it,just put a thin screwdriver(i.e.-pocket screwdriver) and least 4 inches long,press it straight down and pull it out of park-with your foot on the brake pedal of course)get this fixed asap-drop the panel under the dash,under the steering wheel-on the brake pedal assembly,theres a part where the switch goes,get the part before you start the job and youll recognize it right away,depress the tab and turn it clockwise to remove it,on the new switch,pull the detent switch all the way out before installation,put some type of bar between the seat and the brake pedal with vehicle on and adjust the seat to press the pedal down and keep it down,install the switch and release the pedal slowly to push the detent switch back it,once its all the way down,grab the pedal by hand and slightly pull it towards you,it should click one more time,now its adjusted,put the panel back on and your golden,just saved about $200 bucks in diag. and install labor-good luck bud
jess

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 06, 2009

SOURCE: Parking Brake Alarm

inset the key and switch on to position 2
Scroll through the warning display untill you get the service indicator apears
Press and hold the reset button on the left of the dash apnel for about 4 mins
You will be asked if you want to reset
Press anh hold the reset button again until you hear an audible warning
It should now show the new interval to a service

TampaNative

Frank Fernandez

  • 778 Answers
  • Posted on Jul 03, 2009

SOURCE: ML270, multiple warning lights

Yes it could be that simple and probably is.

Anonymous

  • 203 Answers
  • Posted on Jul 22, 2009

SOURCE: stop the car is too low... i rise it.. but 10 km

you have a leak in your airmatic suspension system. scn car for codes to see what component is leaking. usually it is one or bothof the front air springs where the line connects in the upper fender well. you can try jacking the car up and spray soapy water on the line connection-you will probably hear it anyways. they tend to leak when the suspension is unloaded, either way i would check the whole system to be safe

Jason Johnson

  • 1619 Answers
  • Posted on Apr 25, 2010

SOURCE: my car is jerking while driving.

Have engine wiring harness checked as 1993-1995 MB's were forced by US to use biodegradanle insulation on its wires. If thats not it replace coils and do a tunes up.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
2answers

How to adjust parking brake on 1993 chevy lumina ?



  • Adjustments




  1. Apply service brake pedal three times with a force of approximately 175 lbs.


  2. Fully apply and release parking brake three times. Full application may require two pedal strokes.


  3. Raise and support vehicle, then mark relationship between wheel and axle flange.


  4. Check parking brake pedal assembly for full release as follows:






    1. Turn ignition switch to On position.


    2. If ``Brake\'\' lamp is illuminated, operate manual brake release and pull downward on front parking brake cable to remove slack from pedal assembly.





  1. Remove rear wheel and tire assemblies, then install two lug nuts to retain each rotor assembly.


  2. If two parking brake levers on both calipers are not against lever stops on caliper housings, check for binding in rear cables and/or loosen cables at adjuster until both left and right levers are against their stops.


  3. Tighten parking brake cable at adjuster until either the left or right lever begins to move off the stop, then loosen adjustment until lever moves back barely touching stop.


  4. Operate parking brake several times to check adjustments. A firm pedal feel should be obtained by pumping pedal two full strokes and rear wheels should not rotate forward when parking brake is fully applied.


  5. Install wheel and tire assemblies, aligning marks made in step 3.

0helpful
1answer

Car pulls foreward when stopped

might be the brake master.
0helpful
1answer

Emergency brake stuck

your going to have to take off a rear tire and either get it loosened or replaced or cut,but get a haynes repair manual it will tell you step by step what to do and your local auto parts store should have one or check on ebay
0helpful
1answer

Jetta break light is on and when driving it beeps??

It might be the parking brake warning - you may need to check the parking brake switch.
0helpful
2answers

Can't move the shifter out of Park after starting engine on my 2000 Taurus. To drive the car, I have to stop the engine, turn the key slightly back, move shifter to Neutral and restart the engine. How...

This might sound strange, but check your stopping lights and make sure they're working. If I'm not mistaken, this model had a stop light "feature" that prevented the car from moving from the park position if required lights were blown out.

The other problem could be your pawl in the transmission. Sometimes, if you don't use your parking brake, a groove can shave into it. This is usually if you are often parking on an incline, in which you should use your parking brake to avoid pawl grinding.

I'm sure you checked for nobs or release buttons, but I figured I would mention it just in case. I know my car has one, but if you drive this car often...I'm sure you knew it was there to begin with.

Good luck!
1helpful
1answer

The gear is getting stuck... i press on brakes and when car is in park it is hard to put on reverse.. the car runs great...

In all probability the brake sensor on the pedal is starting to work erratically. This sensor sends a signal to the shifter gate, and the gate will not open unless the brake pedal is depressed. I had it happen to me, and the only solution until i replaced the sensor was to hit the brake over and over until the stop light worked (You can check it while looking at the 3rd stop light in the rear view mirror). If the stop lights work, the shifter gate should allow the shifter to move out of park. This sensor/ switch is located about 3 inches above the brake pedal, and it is easily recognizable by the cable attached to it.
0helpful
2answers

When in park hard to move shift stick out of park

Moving the shifter out of park is sometime diffucult if the vehicle is parked on an incline or decline?
Not finding what you are looking for?

1,080 views

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...