My window would go up but not down unless hooed direct the motor and reg we were replacing at the time the switch was good because we plugged in to a different window and it worked fine. now all those things i mentioned dont work but the car does start and everything else works what doi need to check?
SOURCE: Power Windows and Sun Roof no function
A class merc,sunroof slightly opens then stops, semi auto clutch wont gear down into 3rd gear, can any one tell me what the problem could be???
Steve
SOURCE: I have a 92 Lexus
Hi
Thanks for using FixYa. First of all you’ll need to check
battery voltage, recharge it if it is low or jump start with another battery
charger. Inspect, clean and tight both ends of all battery cables. Also check,
clean and tight wiring connections. Check for voltage at relay. If relay has
voltage but there is no "click" when key is turned to start, replace
relay. Remove starter and inspect drive gear and flywheel teeth, replace
damaged parts if necessary. Check to see if voltage reaches starter relay/solenoid
when turn to start. If not, check for open P/N switch and brake or clutch pedal
switch. Please pry the
interior panel and release the inside door locks. If still the issue is not
resolved then you’ll need to drill a two inch hole into the latch to access the
inside lock link through the interior panel. After removing the panel replaces
the latch to resolve the issue. See the picture where to drill---
Please do accept the solution if the issue is
resolved or else revert for further assistance.
Thanks
Rylee
SOURCE: 2000 chevy truck power window problem. Window just
Okay, the window circuit in your truck is different from most power window circuits, in that the master switch provides battery positive power to the driver's window and only provides grounds for the relays that control the passenger window. The master switch is probably not getting the battery power needed to operate the driver's window. Since both windows are supplied battery voltage from the same self-resetting breaker - and the passenger window works, then the breaker is good. The next step is to check for battery voltage at the DARK GREEN wire at the driver's door switch on pin "F". I'm not really a betting man, but I would wager that there is no power there. If you find that battery voltage is not present at the switch, the MOST LIKELY cause would be that the DARK GREEN wire is broken inside the umbilical between the body and the door. The proper way to fix this is to remove the wiring harness from the door and disassemble it to access the wires. This way, it can be put back as close as possible to original. Some mechanics are not willing go through all of this and will cut the umbilical. (Rubber protection sleeve) This can get your window to work, but leaves the wires exposed for future damage. I personally don't recommend this. It takes a lot more time and effort to do this correctly, but in the long-run it is worth it.
Please also review this article: What Else Could Be Wrong?
SOURCE: Nissan Altima 2006 windows,locks,sun roof,and
I looked through all the wiring diagrams for your car for each of those circuits, I do see one fuse in common for each one but am almost sure it is a main relay for the body control modulr itself. Below is the wiring diagrams for each of the circuits you are talking about. In each one it does show a main fuse that is right at the battery. A 50 amp fuse (see red arrow in each picture). Other than that I am pretty sure you are dealing with the body control module itself. There are ways to re-route the wiring to get power to each circuit but it is detailed but can be done. If you are unable to get the body control module (if it is bad and not the fuse by the battery) and need some instructions on re-routing, feel free to email me at csautomotivecars@att,net. I will do my best to give you instructions and pictures to take care of it. If the fuse is blown be sure to disconnect the battery before you replace it. Also if it is blown you may be looking at another problem as to why it blew in the first place. I know this sounds kind of confusing but your vehicle is controlled by modules/computers that control everything from how the engine runs and all the electrical features. I hope this helps you a liltte at least. Here are those wiring diagrams:
Testimonial: "thanks"
SOURCE: 1998 olds 88 wont start no power windows or seats
ok i have fix this problem today. take out the switch for the seats and place a ground on the ground wire that solved the one i fix it lost gruond on that side of car
36 views
Usually answered in minutes!
×