Need various heater hose parts for my 1999 Chevy Venture. My mechanic said they don't manufacture the parts anymore. He gave me a diagram and highlighted the pieces I need. Problem is that I don't know the name of the pieces.
You should be ableto obtain a diagram of the heater hose circuit from the dealer evenj though he doesn't carry the part. If not,autozone or an alike store should be able to come up with one. Then take it to your mechanic and have him mark the parts you need.someone will have the parts even if you have to go to the salvage yard
HI,HERE'S A LINK TO YOUR HEATER HOSES. Hose Heater 1999 Chevrolet Venture FWD 6 Cylinders 3 4L SFI AutoZone com
Hose Heater at AutoZone com Best Hose Heater Parts...
Shop for Hose Heater products with...
SOURCE: Venture Van - Fuse panel diagram
you need to call the gm part department and ask for a fuse diagram they can print you out one so you can keep it wwith your vehicle. Please rate my response thak you very much
SOURCE: DIC doesn't work
Are you talking about the one in the roof console, near the windshield?
With the key OFF:
Depress and hold the MODE and the ENGLISH/METRIC buttons.
With these two buttons still depressed, turn the ignition switch to the RUN position.
When you do this all display segments will light for 2 seconds then off for 2 seconds, then it should show "PS" then turn off. After this, then unit may show E1, E2, E3 or E4. If E and a number (E1) didn't come up, then there are no errors in the System.
Turn the van off, then....to set the compass, find your location on the map picture. The number you fall under is your zone number.
Turn the ignition ON.
Cycle the driver information center (DIC) to the Compass/Temperature mode.
Press both the E/M and the MODE buttons for approximately 5 seconds.
The last entered variance zone number will be displayed.
Press the E/M button until the proper variance number (See picture) is showing.
Press the MODE button in order to set the new variance zone and resume normal operation.
Note: The features are controlled by outside data. The only feature that is self contained in the unit is the compass, and if it is not working correctly, then the unit is malfunctioning and I would suggest replacing it with a new one.
Perform these steps on more time. If it still does not work right, then the unit will need to be replaced.
Turn the ignition ON.
Cycle the driver information center (DIC) to the Compass/Temperature mode.
Press both the E/M and the MODE buttons for at least 10 seconds until the calibration symbol appears.
Release both buttons once the calibration symbol appears.
Complete 3 360° turns in an area free from large metal objects.
But I would wait before replacing it. Drive it around normal for a day first. If it nothing happens then, then replace it. The compass will not always calibrate right away.
Good luck and hope this helps.
SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?
passengers side under the hood.....by the firewall.....
SOURCE: Need coolant hose diagram for 1992 Chevy Cavalier
it makes no difference as long as you have coolant going it and out
337 views
Usually answered in minutes!
×