Dash Box Cover

Most American-made cars have a fuse box under the dash. Check under dash at driver's side firewall. May have a cover that you will need to open. Also see fuses under hood in area around the steering column.

I have a 2008 Dodge avenger my lights was working and then his started flat by dash light started flashing now my brake lights won't work and my dash lights work work

most fuel pump relays are located in the main fuse box,under the hood. look for a black box on the drivers side,or passenger side fenderwell under the hood. lift cover off and look on underside of the fuse box lid for location of the fuel pump relay and main engine fuse.hope this helps and thank you for choosing fixya.com

If it's the same as a 2005 it's in the right end of dash. Open door pull little cover off end of dash.

Changed battery but radio never came back on

Your cabin filter is hiding above/behind your glove box. In order to access the cabin filter, first remove the passenger instrument panel side cover. Next, open your glove box and there should be one clip on the left and right side of the glove box... remove those clips as well as the tether that is holding the glove box up. After the glove box falls forward, remove the upper storage box. You should now see the cabin filter access panel, which is held in with 5 or 6 screws. Remove the screws, pull the access panel out, and you should see the cabin filter. Reverse instructions for installation.
Please let me know if I may further assist you. -TXTEXAN

Location of Keyless Code on Computer Module of Ford F250 Superduty ( 2009 )

Finding this code seems to be a common problem, so, here is a better answer to save you the time I spent locating the sticker on the computer module that shows the keyless entry code.

One owners from 2008 F150 XLT Superduty tell me and I suspect the location for a F150 would be very near same location as on a F250

The computer module is mounted high on the firewall approximately behind the a/c fan speed control knob. Here is how to find it / get to it:

1. Remove the large cover under the steering column that covers the fuse block. You'll need to reach in under the dash, with your left arm, to the right of the steering column and left of center to move stuff to get a clear view.

2. Open the storage pocket door on the lower edge of the dash (right of the steering column) and squeeze the back side of the storage pocket to allow the stops to pass to the front. This will allow the opening to be clear to see the computer module up in the dash. Shine your flash light through this opening.

3. Move the first piece of white insulation to the side to see the firewall. Look up through the pocket door, moving the wiring harnesses aside if necessary. You'll find a second white insulation wrapped snugly across the computer module. When you push the insulation up to see the flat surface, you see the 5 digit number printed up-side-down in black on a white sticker. This is your keyless entry code.

Instructions for Programming Keyless Entry Code (from the 2008 Owner's Manual)

KEYLESS ENTRY SYSTEM (IF EQUIPPED)
You can use the keyless entry keypad to lock or unlock the doors without using a key.

The keypad can be operated with the factory set 5–digit entry code; this code is located on the owner’s wallet card in the glove box, is marked on the computer module, and is available from your authorized dealer. You can also create your own 5–digit personal entry code.

When pressing the controls on the keypad, press the middle of the controls to ensure a good activation.

Programming a personal entry code
To create your own personal entry code:
1. Enter the factory set code. The driver door will unlock.

2. Within five seconds press the 1 • 2 on the keypad.

3. Enter your personal 5-digit code. Each number must be entered within five seconds of each other.

4. The doors will lock then unlock to confirm that your personal keycode has been programmed into the module.

Tips:
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.


Good Luck (remember comment and rated this).

Try replacing the bulb. the cover should pop right off. next you could try to check the fuse box it should be on the side of the dash or under the driverside dash.

open ur hood
look at the fuse box
theres a lil tool inside with extra fuses
to help pull the fuses out

use a screw driver around the cover that goes around the vent and facia cover pry gently