How to change starter on 2000 Isuzu rodeo

SOURCE: how to change oil transmission isuzu rodeo 2003

There are two drain plugs on the bottom of the pan. remove the lower one to drain the trans fluid. To refill, use a pump and pump the fluid into the upper drain plug until it seeps out and re-install the plug, similar to refilling a manual trans.
Once this is done, Start the vehicle and run it for about 3 minutes, shifting through all gears (do not drive vehicle Remove the upper drain plug and let any excess fluid drain out. Done. This is as per Mitchell OnDemand.

SOURCE: 2000 isuzu rodeo brake problems

your master cylinder is gone. when stopped apply pedal and hold let up slightly then reapply if pedal sinks to floor master is bad.

SOURCE: where is air cabin filter located on 99 isuzu rodeo?

its usually behind the glove compartment in the blower box. you will have to pull the GB door down all the way to access it

SOURCE: Crank Sensor in 94 Isuzu Rodeo

it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)

SOURCE: brake light bulb

I have a 2000 Isuzu Rodeo and had the same problem. On the 2000, there are 2 screws on the side of the light assembly and 1 at the bottom the need to be removed. I found I needed a longer philips screwdriver for the bottom screw as there is not much room. Once you remove the screws, pull straight back on the unit. There are 2 plastic pins that are about 3/4" that will pop out of their socket when you pull straight back. Then, just lift the unit out and replace the bulb.