Drive light on or flashing with the engine running means a transmission problem. Often it's a bad sensor. Many auto parts stored will read the odd code for free, in the hope you'll buy pat from them. Don't delay diagnosed, even if you have go pay a deal er to read the code.
SOURCE: Check engine and d4 lights on
d4 is flashing as a trouble code for the automatic transmission... i would say without research that it is a code for a transmission solenoid. maybe while washing the car some water got in and caused a short...these solenoids are usually weatherproof....you could try disconnscting the battery for 30 secs..to clear the trouble code and then start the car. remember you may lose your preset info!
SOURCE: drive 4 light flashing when i put the key in.
This light is flashing to indicate a fault has occurred in the transmission, have a test run on the control module of the trans to figure out what that might be, it could be a simple fix once you have the trouble code.
SOURCE: engine turns over fine , car will not start.
well the first part of your question i was all ready to tell you to put a new fuel pump in, now not so sure, there is a relay for fuel pump, can you hear pump cycle and relay click? relay under hood you will have to listen close they don't run long maybe a couple secounds, if you don't relay bad. if you do pump could be bad, do fuel pressure test pump could be weak. don't think sunroof and turn signals are related, but stranger things have happend.
SOURCE: lights on dash, drive,park, reverse, etc flash after starting car
check the transmision codes with obd1 tranny in safe mode. check droping resistor. Vitally
117 views
Usually answered in minutes!
×