Holden commodore problemsi have a vy commodore brakes just re-knewed but carnt see where to adjust hand break cable mcan u help

SOURCE: Holden 94 rodeo petrol

Good Day
Vale clearance cold
intake .006 in (.15 mm)
exhaust .010 in (.25 mm)

Timing
1. With transmission in Neutral or park, start engine and warm to normal operating temp. turn eng,and all accessories off. connect Tachometer. Connect timing light to no 1 spark plug wire.

2. Disconnect and plug fuel vapor canister purge hose and EGR vacuum hose. Start and ensure idle is 900 RPM. adjust idle as required. Check ignition timing ( 12 @ 900)

3. If adjustment is required, loosen distributor hold down bolt and turn until timing is within specification. Tighten distributor hold down bolt and recheck timing. adjust idle speed as required.

hope this helps

Cheers

SOURCE: Rear brakes need ajustment on Buick Lesabre

I don't know if this works on a Buick but I have had two cars that the auto adjusters worked when you used the parking brake, I rarely use the parking brake so I got in the habit of working the parking brake 20 times or so at oil change time.

Remontti-J

• 32 Answers
• Posted on Jun 05, 2009

SOURCE: pt cruiser parking brake ajustment

Hello,
It is manual adjustable.

Here is the photo where you can find it ("saatoruuvi"= "adjustable srew")

http://www.ptcruiser.fi/ptgalleria/albums/userpics/Jarrukengat.jpg

SOURCE: how do i ajust a ford mondeo gear linkage

if memory serves me right you cannot adjust the cables on these cars.

SOURCE: how to change cool'nt in a VE commodore holden

to change the coolant in any engine you need to firstly remove the bottom radiator hose when the engine is cold not when the engine is hot and drain the whole system.
You then need to get some coolant from your local supplier and it will tell you on the container the proper ratio of water to cool it. Once you have put to cool it in top up the system with clean water.Regards