Did you check for battery voltage at the switch , with a volt meter before you replaced the main driver door switch ? Maybe you'll want to take this to pro ,instead of just replacing parts !
Symptom Chart
Condition
Possible Sources
Action
- No communication with the smart junction box (SJB)
- REFER to Section 419-10 .
- A single power window is inoperative - driver front power window is inoperative/does not operate correctly
- Power window motor regulator and motor
- Circuitry
- Window control switch
- Smart junction box (SJB)
- A single power window is inoperative - passenger front, left rear or right rear
- Power window motor regulator and motor
- Circuitry
- Window control switch
- All power windows are inoperative
- Smart junction box (SJB) fuse 30 (10A)
- SJB circuit breaker 10 (30A)
- Circuitry
- Delayed accessory relay
- Battery saver relay
- Driver window control switch
- SJB
PINPOINT TEST C: ALL POWER WINDOWS ARE INOPERATIVE
Test Step
Result / Action to Take
C1 CHECK FOR CORRECT OPERATION OF THE INTERIOR LIGHTS
- Turn on the interior lights.
- Do the interior lights operate normally?
Yes
GO to C2 .
No
To continue diagnosis, REFER to Section 417-02 .
C2 CHECK CIRCUIT 400 (LB/BK) FOR VOLTAGE TO THE DRIVER WINDOW CONTROL SWITCH
- Disconnect: Driver Window Control Switch C504b.
- Key in ON position.
- Measure the voltage between the driver window control switch C504b pin 4, circuit 400 (LB/BK), harness side and ground.
>
- Is the voltage greater than 10 volts?
Yes
GO to C4 .
No
GO to C3 .
C3 CHECK CIRCUIT 400 (LB/BK) FOR AN OPEN OR SHORT TO GROUND
- Key in OFF position.
- Disconnect: SJB C2280c.
- Measure the resistance between the driver window control switch C504b pin 4, circuit 400 (LB/BK), harness side and the SJB C2280c pin 17, circuit 400 (LB/BK), harness side; and between the driver window control switch C504b pin 4, circuit 400 (LB/BK), harness side and ground.
>
- Is the resistance less than 5 ohms between the driver window control switch and the SJB; and greater than 10,000 ohms between the driver window control switch and ground?
Yes
Go To Pinpoint Test H
No
REPAIR the circuit. TEST the system for normal operation.
×