Diagnosic code po340
P0340 Dodge - Camshaft Position Sensor Circuit Bank 1 Sensor 1 P0340 Dodge Camshaft Position Sensor Circuit Bank 1 Sensor 1
SOURCE: 2005 dodge diesel codes!
Hi..
the Code P0340, Camshaft Position sensor problem or Loss signal.
The Code P0341, Camshaft Position sensor Intermitent Signal.
The First step you should do is : Locate the Camsahaft sensor,
Is located On Right Front of the Engine..
It use a 3 wires Connector.
1-- Pink/Yellow
2-- Brown/Orange
3-- Dark blue/Gray.
After you found it. Inspect the Connector. If is The connector in good condition.
Replace the Camshaft Position sensor...
Ok... I hope this help on your problem..
Thank you for use Fixya...
SOURCE: trouble codes and why
my check engine light has been on for a few months and now my oil light flickers. what doesn this mean?
SOURCE: Problem codes came up after check engine light
the1684 is letting you know battery was recently disconnected. 0340 is camshaft position circut failure.
SOURCE: have2004 intrepid shows engine light and error
code po 340 no camshaft position sensor signal at powertrain control module and code po344 rationality error detected for intermittent loss of camshaft position sensor circuit. hope this will help you!!!!
SOURCE: engine light came on and then car wouldnt start
Disconnect your battery terminals before you start.With this code it is telling you that there is no signal from the camshaft position sensor to the Electronic Control Module.By changing this sensor you can take care of the check engine light and your starting problem.The sensor is located on the drivers side at the end of the cylinder head.You might have to move some wires out of your way to get to the bolts.Take the bolts out and remove the cover.Now in order to get the sensor out you have to take the torx screw to get it out.Its not to bad to do if you take your time.
863 views
Usually answered in minutes!
×